Check Mower Blades. Exmark PIONEER PNS20KA443, PIONEER PNS22KA483, PIONEER PNS24KA523, PIONEER S-SERIES Operators


Add to my manuals
52 Pages

advertisement

Check Mower Blades. Exmark PIONEER PNS20KA443, PIONEER PNS22KA483, PIONEER PNS24KA523, PIONEER S-SERIES Operators | Manualzz

Maintenance

DANGER

Jump starting a weak battery that is cracked, frozen, has low electrolyte level, or an open/shorted battery cell, can cause an explosion resulting in serious personal injury.

Do Not jump start a weak battery if these conditions exist.

2. Make sure the booster is a good and fully charged lead acid battery at 12.6 volts or greater. Use properly sized jumper cables (4 to 6 AWG) with short lengths to reduce voltage drop between systems. Make sure the cables are color coded or labeled for the correct polarity.

CAUTION

Connecting the jumper cables incorrectly

(wrong polarity) can immediately damage the electrical system.

Be certain of battery terminal polarity and jumper cable polarity when hooking up batteries.

Note: The following instructions are adapted from the SAE J1494 Rev. Dec. 2001 – Battery

Booster Cables – Surface Vehicle Recommended

Practice (SAE – Society of Automotive

Engineers).

WARNING

Batteries contain acid and produce explosive gases.

• Shield the eyes and face from the batteries at all times.

• Do Not lean over the batteries.

Note: Be sure the vent caps are tight and level.

Place a damp cloth, if available, over any vent caps on both batteries. Be sure the vehicles do not touch and that both electrical systems are off and at the same rated system voltage. These instructions are for negative ground systems only.

3. Connect the positive (+) cable to the positive (+) terminal of the discharged battery that is wired to

the starter or solenoid as shown in Figure 21.

Figure 21

1.

Positive (+) cable on discharged battery

2.

Positive (+) cable on booster battery

3.

Negative (–) cable on the booster battery

4.

Negative (–) cable on the engine block

5.

Booster battery

6.

Discharged battery

7.

Engine block

4. Connect the other end of the positive cable to the positive terminal of the booster battery.

5. Connect the black negative (–) cable to the other terminal (negative) of the booster battery.

6. MAKE THE FINAL CONNECTION ON

THE ENGINE BLOCK OF THE STALLED

VEHICLE (NOT TO THE NEGATIVE POST)

AWAY FROM THE BATTERY. STAND BACK.

7. Start the vehicle and remove the cables in the reverse order of connection (the engine block

(black) connection is the first to disconnect).

Check Mower Blades

Service Interval: Before each use or daily

1. Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

2. Lift deck and secure in raised position as stated in the Clean Grass Build-Up Under Deck section.

3. Inspect blades and sharpen or replace as required.

4. Reinstall the blades (if they were removed) in the following order:

A. Install the blade onto the spindle shaft.

31

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals