Adjusting the Seat Ride Suspension. Exmark PIONEER PNS20KA443, PIONEER PNS22KA483, PIONEER PNS24KA523, PIONEER S-SERIES Operators


Add to my manuals
52 Pages

advertisement

Adjusting the Seat Ride Suspension. Exmark PIONEER PNS20KA443, PIONEER PNS22KA483, PIONEER PNS24KA523, PIONEER S-SERIES Operators | Manualzz

Maintenance

1.

Nut

2.

Turnbuckle

3.

Stationary plate

Figure 32

4.

Control plate

5.

Return to neutral plate

6.

Tabs touching return to neutral plate

8. Tighten nuts.

9. Shut off unit. Remove jumper wire from wire harness and plug connector into seat switch.

10. Remove the jack stands.

11. Raise the deck and re-install the height of cut pin.

12. Check that the machine does not creep in neutral with the park brake disengaged.

1.

Bolt

2.

Spring

Figure 33

3.

Nut

4.

Additional mounting holes

Up to five springs can be secured to the seat box with

a nut and bolt, see Figure 33.

Refer to the Parts Manual for spring and hardware part numbers.

Electric Clutch Adjustment

No adjustment necessary.

Adjusting the Seat Ride

Suspension

The number of seat springs can be changed to maximize rider comfort. More springs should be used with heavier operators and on rough terrain. Fewer springs should be used with lighter operators and when mowing smooth, well established lawns. Always keep the number of springs on the left and right side the same when adding and removing springs.

41

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals