10.2 On-Board Charger Operation. Lester SUMMIT 28000, Prime, SUMMIT 28230, SUMMIT 29180, SUMMIT 28110, SUMMIT 28120, SUMMIT 27940, SUMMIT 27950, SUMMIT 27800, SUMMIT 27790

Add to my manuals
20 Pages

advertisement

10.2 On-Board Charger Operation. Lester SUMMIT  28000, Prime, SUMMIT  28230, SUMMIT  29180, SUMMIT  28110, SUMMIT  28120, SUMMIT  27940, SUMMIT  27950, SUMMIT 27800, SUMMIT 27790 | Manualzz

10.2 On-Board Charger Operation

If the charger was factory-configured for on-board use, follow these operating instructions:

1. Ensure that the vehicle/equipment that the charger is mounted on is turned off.

2. With the charger AC power cord disconnected from the AC outlet, connect the charger DC output connector/plug to the battery connector/receptacle (most likely already connected or hard wired).

3. Connect the charger AC power cord to an appropriate AC outlet. The charger will start automatically, which is indicated by the Charge Status (yellow) LED beginning to blink slowly.

4. If the charger must be disconnected from the battery while a charge cycle is in progress, disconnect the AC power cord from the AC outlet. Do not disconnect the charger DC output connector/plug from the battery while a charge cycle is in progress.

5. The charge cycle 80% point is indicated by the Charge Status (yellow) LED beginning to blink quickly.

6. The Finish charge cycle phase is indicated by the solid illumination of the Charge Status (yellow)

LED. Not all charge profiles include a Finish phase.

7. An extended Balance/Equalize charge cycle phase is indicated by the Charge Complete (green)

LED beginning to blink quickly. Not all charge profiles include a Balance/Equalize phase.

8. The charger automatically terminates the charge cycle when a battery reaches full charge, which is indicated by [1] the solid illumination of the Charge Complete (green) LED or [2] the Charge

Complete (green) LED beginning to blink slowly indicating a post-charge phase. The required charge time is affected by numerous factors, including battery amp-hour capacity, depth of discharge, battery temperature, and battery age/usage.

9. Disconnect the charger AC power cord from the outlet before operating the vehicle/equipment.

10.3 Storage Mode Operation

1. Storage Mode is designed to keep your battery maintained during storage periods that last a few weeks to several months at a time.

2. Depending on the battery type, a storage charge can be a continuous float or a periodic charge mode.

3. Do NOT disconnect the charger from the battery or from the AC power while your machine is not being used Disconnecting and reconnecting the charger from the batteries or AC power may start a charge cycle, but disconnection disrupts the storage mode so optimum battery maintenance is not achieved.

4. After several months of storage your batteries should be serviced and the charger reset by disconnecting the DC for Off-Board or the AC for On-Board applications (disconnect AC for a minimum of 10 minutes) before continuing another storage season..

Summit Series ® 14 of 20

User’s Manual

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals