946001 3130 Hor Band Saw.pmd

946001 3130 Hor Band Saw.pmd

General

Specifications

The Wilton 5x8 cutoff bandsaw is available as a dry cutting bandsaw or as a wet cutting bandsaw. If required, a dry cutting bandsaw can be retrofitted with a kit which converts it to use with cutting fluids.

The use of a hydraulic feed delivers consistent accurate cuts and longer blade life.

4

Cutting capacity

Speeds

Blade drive

Saw guides

Motor

Blade wheels

Saw blades

Floor model dimensions

Optional wet cutting pkg.

5 inch (127mm) round

7 1/2 inch (190.5mm) wide x 5 inch (127mm) high rectangle

8 inch (203.5mm) wide x 1 inch (25.4mm) high flat stock

4 1/2 inch (114.3mm) wide x 5 inch (127mm) high at 45 degrees

85,125,200 SFM

Steel, heat treated worm driving a bronze worm gear in an oil bath

Ball bearing mounts on an eccentric shaft, ball bearing rear guide bearings -- all bearings sealed and permanently lubricated

1/2 HP, 115/230V, 1725RPM capacitor start

7-3/8 inch (187mm) diameter flanged cast iron

1/2 x .025 x 68 inches

Width 16 inches overall (400mm)

Height 38 inches overall with arm horizontal (950mm)

Height 58 inches overall with arm vertical (1450mm)

Length - 38 inches (950mm)

1 gallon (4.5L) capacity tank, pump motor: single phase 120V

Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project