Vital Signs Monitor Operator`s Manual

I.

Printer Feed Button

Pressing this button advances the paper in the printer.

J. Mounting Keyholes

Mounting accessories are attached via these keyholes.

K. Battery Compartment

Contains the internal battery. Removal of 4 screws allows changing battery without affecting other internal parts.

Set-Up Procedure

AC Power Connection

The Welch Allyn Vital Signs Monitor may be powered by either AC power or battery power after the battery has been charged.

To install the AC power transformer, insert the round transformer connector into the power port on the side of the Monitor as shown. Insert the connector into the port until it is fully seated. Insert the line cord into the line connector on the transformer.

To power the Welch Allyn Vital Signs Monitor, plug the line cord into the AC mains power source.

16

Inserting the AC power transformer connector into the Monitor port.

Vital Signs Monitor