Applying Frame Protection. GT Zum, 2015, Bike

PaRt ii

aPPlyinG fRame

PRotection

Some areas of your bicycle require protection from abrasion. If protection is not in place, damage can result. Please consult with your Authorized GT

Dealer about the replacement location and position of these various frame protections.

note: Damage to your bike resulting cable rub is not covered

under your warranty. Make sure the protections indicated below are in place whenever you ride your bike. Ask your GT Dealer for help.

housing and cable Guides

Normal line and cable movement against the frame can wear away painted finishes and decals.

Also, adhesive frame guards are not a fix for incorrectly installed or routed cables or lines. If you find that applied guards are wearing out very quickly, consult with your GT Dealer about the routing on your bike.

Figure 24.

THIS PHOTO SHOWS A TYPICAL USE OF

GUARD MATERIAL AT A CONTACT POINT.

■ Headtube area

■ Seattube

■ Pivots areas

■ Anywhere a control cable or housing may contact the frame.

Figure 23. to apply the guard material:

1. Clean the frame with a mild detergent and wipe dry with a clean towel. Do not use solvents or harsh chemicals to clean the frame. OPTIONAL:

Trim the adhesive guard material to the shape required.

2. Remove the backing and position the guard under the cable/ line.

3. Rub the guard firmly against the frame with your fingers to fix it in place.

4. Periodically, recheck the guards and other areas of the frame as you continue to ride. Replace the guards if they wear out.

CAUTION

Over time, cable rubbing can wear into the frame itself causing very serious frame damage.

Check over your bike after your first few rides.

Apply the guard material where rubbing is found. When applied correctly and renewed when worn, the guard material is good protection for your bike.

80 81

PaRt ii

80

Right chainstay Plate

On mountain or road bikes, the chainstay plate is located on the right chainstay just behind the chainrings. This plate protects the carbon

(composite) chainstay from damage in the event the chain is dropped from the chainring.

chainstay Protector

On mountain or road bikes, the chainstay protector is a clear, adhesive film applied to the upper surface of the right chainstay. This protector can prevent damage to the chainstay caused by the chain.

On mountain bikes, a wrap-around or snap on type protector can be installed as additional protection.

Figure 25.

Downtube Protector

On mountain bikes, placement on the down tube protector on the downtube reduces the potential for damage caused by debris thrown by the wheel. For some bikes, the protector is a fitted adhesive backed material. Some bike models may have light weight plastic formed guards.

Figure 26.

81