advertisement
Firmware User
’s Manual V6.05.xx
Image
The section
Image
allows user to control certain parameters of a video frame.
For D / E / B Series
For I-Series Only
Parameters
Video Flipping / Video
Mirroring
Brightness
Contrast
Saturation
(for I-series only)
Digital Noise
Reduction
WDR
3D Noise Reduction
(for I-series only)
Description
Check this box to flip the video up-down and left-right to achieve the
180-degree rotation effect.
Select the Brightness value (0~100). The higher the value, the brighter the image.
Select the Contrast level from following options: Lowest, low, medium, high, highest
Saturation makes colors appear more vivid. Select the Saturation level from the following options: Disabled, low, medium, high, highest.
Turn ON or OFF the Digital Noise Reduction. When turned on, the noise on the video (especially in low light) is reduced and image will look smoother and clearer.
Choose the WDR level from following options: Disabled, low, medium, high, highest.
NOTE:
WDR is disabled and will not appear on screen if
Exposure
Mode
is set to
“Manual”.
Enable this feature for smooth and clear image. Disable this feature if the scene contains extreme details that may be smoothed over with
3DNR.
Firmware User
’s Manual V6.05.xx
Edge Enhancement
(for I-series only)
Select the Edge Enhancement value. The higher the value, the sharper the image.
After changing any of the items above, press
Apply
to save the changes. The Reset button undoes the changes that had just been made but not Applied yet.
The button
“Restore image settings to default”
is a quick way of restoring factory default image settings without needing to reset the whole camera to factory default.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 6 Connect the Equipment
- 6 Configure the IP Addresses
- 10 Access the Camera
- 12 Login
- 13 Live View
- 17 View Modes
- 18 ePTZ View Mode
- 19 Panorama View Mode
- 20 Fisheye View Mode
- 21 PTZ Control Panel (For PTZ and Zoom Cameras)
- 21 How to Use Pan/Tilt
- 22 How to Zoom the Camera In or Out
- 23 How to Set the Home Position
- 23 How to Set Serial Hex Command Protocol
- 23 How to Adjust the Focus
- 24 How to Set Touring Preset Points
- 24 How to Set and Enable Tours
- 26 Access the Setup Page
- 28 Date & Time
- 30 Network
- 30 IP Address Filtering
- 32 Port Mapping
- 34 HTTPS
- 35 IEEE 802.1X
- 37 SNMP Setting
- 41 Network (ToS, UPnP, Bonjour, ONVIF)
- 44 IP Settings
- 44 Connection Type
- 50 Video & Audio
- 50 Camera Options on Fisheye Cameras
- 51 Camera Options on 1.3MP Cameras
- 52 Compression
- 55 Motion Detection
- 60 Day/Night
- 61 Image
- 63 Exposure / White Balance
- 67 OSD/Privacy Mask
- 70 On-Screen Graphics
- 72 Audio
- 73 Event
- 73 Event Server
- 76 Event Configuration
- 83 Event List
- 86 Manual Event
- 87 Local Storage Management
- 88 Status
- 89 Utilities
- 94 Setup
- 95 File Management
- 101 Event Handler with Local Storage
- 108 System
- 108 User Account
- 109 System Info
- 110 Factory Default
- 111 Firmware Upload
- 112 Save & Reboot
- 113 Logout