Appendix A - ADM Icons Overview. Graco 313997ZAA - HFR, HFR

Add to my manuals
112 Pages

advertisement

Appendix A - ADM Icons Overview. Graco 313997ZAA - HFR, HFR | Manualzz

Appendix A - ADM Icons Overview

Appendix A - ADM Icons Overview

Setup Screen Icons

Icon Description

Enter Screen

Icon Description

Erase All Counters on Page

Access Flowmeter Calibration

Exit Screen

On Learn Mode Calibration screen:

Move pump

All other screens:

Begin Dispense

Stop Dispense

Abort Changing the Label

Select left direction

Select right direction

Valve Details

Selects all shots to be changed to the same user specific value

Pressure

Shot Number

Sequence Position

Flow

Time (Duration)

Tank Blanket Heater

Backspace

Back to main calibration screen from learn mode calibration screen or

Back to system screen 2 from mix head operating details screen

Access Learn Mode Calibration screen

Run MCM Learn Mode

Proceed to next step in calibration procedure

On Main Calibration screen:

Calibrate Weight Dispense or Enter

Specific Gravity Information

On Flow Meter Calibration screen:

Use Dispensed Material Weight to

Calibrate Flow Meters. If pressed, icon will change and units are changed to volume units.

Erase Selected Item or Control Data

Primary Heater

Heated Hose

Chiller

Move Cursor to the Left

Move Cursor to the Right

Upper/Lower Case Letters

Positive / Negative

66 313997ZAA

Appendix A - ADM Icons Overview

Run Screen Icons

Icon

OR

Description

Select mode.

Set system in park (icon will be selected when system is parked)

Open, Close Valve

A (Red) and B (Blue) refill button

(Press to start/abort refill)

With a mix head installed:

Turns on the mix head hydraulics and puts the machine in low pressure circulation.

Press a second time to turn off insti gated system action.

If Green:

Allowed to Dispense

If Red:

Not Allowed to Dispense

Stop Dispense

Jump in and use the key pad to select a shot number.

Skip the next shot in selected sequence. Only available when the system is not dispensing.

Abort sequence and reset to first valid position

Edit Operator Dispense Setting

Press to enter the Conditioning Con trol screen

Turn on or off the highlighted zone.

Turn on or off all zones.

Erase a single batch

Erase all batch data points

Icon Description

Sets machine to low pressure

Sets machine to high pressure

Current and setpoint temperature for primary heater. Not displayed if heat zone is not enabled.

Current and setpoint temperatures for heated hose. Not displayed if heat zone is not enabled.

Current temperatures for heated hose monitor. Not displayed if heat zone is not enabled.

Current and setpoint temperatures for tank blanket. Not displayed if heat zone is not enabled.

Current temperatures for tank blanket monitor. Not displayed if heat zone is not enabled.

Current and setpoint temperatures for chiller. Not displayed if heat zone is not enabled.

Current temperatures for chiller moni tor. Not displayed if heat zone is not enabled.

Amount of material moved through pump (volume tracking)

Cycles

313997ZAA 67

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement

Table of contents