ProppFrexx ONAIR
After you have selected a DSP plug from the list of available plug ins, click „OK“ to load and start the DSP. Once a DSP was successfully started and assigned to the mixer channel, the following settings window allows you to control the DSP.
Figure 54: VST DSP Settings
The top tool bar of the DSP settings windows contains the following controls:
Bypass: Switches the DSP plug in processing on/off (VST only).
Preset: Select a program/module preset of the DSP plug in (if available).
Restore: Restore the parameter defaults for the selected program/module preset (VST only).
Editor: Opens the external VST or Winamp plug in editor.
Close: Removes the DSP plug in from the mixer.
The individual parameters of a VST DSP plug in are shown below in the settings window and can directly be controlled/adjusted. Please refer to the DSPs documentation about the parameter values, its use and functionality.
Click on the „Editor“ button to show the external VST or Winamp plug in editor.
Using the Send To Function (SND)
The „SND“ button allows you to send a copy of the audio signal processed by the mixer channel to any other output mixer channel (a blue button indicates, that the SND function is active). This offers you the possibility to route the audio signal to multiple mixer channels and thus use a mixer channel as a group bus receiving multiple audio streams. Right-Click on the „SND“ button to open the send to menu.
An output mixer channel can receive and process the audio signals from any of the internal players as well as from any other input or output mixer channel.
An input mixer channel can receive and process the audio signal of only the soundcard device input.
86
Figure 55: The SND Menu
RADIO42 Confidential
