Operator`s Manual for Basic Functions CX1145 MFP

Add to my manuals
341 Pages

advertisement

Operator`s Manual for Basic Functions CX1145 MFP | Manualzz

2.Turning Power On / Shutdown (Cont.)

1

Turning power off (Shutdown)

When turning OFF the power of the equipment, be sure to shut it down following the procedure below.

Check the following three points before shutdown.

No jobs should be left in the print job list. (

! P.223 “1.Job Status”)

• None of the PRINT DATA, MEMORY RX and FAX communication lamps should be blinking. (If the equipment is shut down while any of the above lamps is blinking, jobs in progress such as FAX reception will be aborted.)

• No PC should access the equipment via the network.

• Do not press the power switch to turn the power OFF, otherwise the stored data may be lost or the hard disk may be damaged.

• When the equipment is shut down, the job in progress is cleared.

1 Press the [ENERGY SAVER] button on the control panel.

2 Press the [SHUTDOWN] button on the touch panel.

• To cancel the shutdown operation, press the [CANCEL] button.

25

1.BEFORE USING EQUIPMENT

3 “Shutdown in progress” appears on the menu. After a while, the equipment is shut down and the power is turned OFF.

1

• The power switch automatically returns to the OFF position.

Turning the power off (Shutting down) with the [USER FUNCTIONS] button

The equipment can also be shut down by following the procedure below.

1 Press the [USER FUNCTIONS] button on the control panel.

2 Press the [USER] button on the touch panel to enter the user setting menu, and then press the [SHUTDOWN] button.

26

2.Turning Power On / Shutdown (Cont.)

1

3 “Processing job will be deleted. Are you sure you want to shutdown?” appears on the menu. Press the [YES] button.

• To cancel the shutdown operation, press the [NO] button.

4 “Shutdown in progress” appears on the menu. After a while, the equipment is shut down and the power is turned OFF.

• The power switch automatically returns to the OFF position.

27

1.BEFORE USING EQUIPMENT

3. Energy Saving Mode

This equipment supports two energy saving modes; the Automatic Energy Save mode and the Sleep

Mode.

Automatic Energy Save

The equipment enters the Automatic Energy Save mode automatically after a specified period of time

*1 since its last use. During this mode, “Saving energy – Press START button” appears on the touch panel.

Sleep Mode

The equipment enters the Sleep Mode automatically after a specified period of time

*1

since its last use.

During this mode, the message of the Automatic Energy Save mode disappears and the [ENERGY

SAVER] button lights in green.

These modes are automatically cleared upon the reception of print data, Fax data, Internet Fax data or Emails. They are also cleared by pressing the [START] button.

*1 This period is set at 3 minutes by factory default.

See the User Functions Guide to change the default settings noted above.

The equipment can also be made to enter the sleep mode manually by means of the following procedure.

1 Press the [ENERGY SAVER] button on the control panel.

1

2 Press the [SLEEP] button on the touch panel.

• The equipment enters into the sleep mode. During this mode, the display on the touch panel disappears and the [ENERGY SAVER] button lights in green.

To canceling the energy saving mode

Press the [START] button on the control panel. The sleep mode is cleared and the equipment will be ready for copying.

The sleep mode is also cleared by pressing any button of [ENERGY SAVER], [COPY], [SCAN], [FAX] and

[e-FILING].

28

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement

Table of contents