Operator`s Manual for Basic Functions CX1145 MFP

Add to my manuals
341 Pages

advertisement

Operator`s Manual for Basic Functions CX1145 MFP | Manualzz

Setting copy paper (size change)

When you set or add copy paper in the drawer, follow the procedure below.

Placing paper in the drawer

1

Turn the power on.

2

Pull out the drawer carefully until it comes to a stop.

3

Push the lower part of the end guide in the direction of the arrow to remove it, then reinstall it at the desired paper size

(indicated on the bottom inner surface on the drawer).

4

Push the arrow part (right side) of the side guide to unlock it.

1

32

4.Setting Copy Paper (Cont.)

1

5 While pushing the green lever of the side guide in the direction of the arrow, set the side guide to the desired paper size.

• Adjust the side guides with both hands.

6 Push the arrow part (left side) to lock the side guide.

7 Place paper in the drawer(s).

• Place paper with its copy side up. (The copy side may be described on the wrapping paper.)

• For the maximum number of sheets that can be set, see

! P.30

“Acceptable copy paper”.

• Fan the paper well before placing it in the drawer.

• Be sure that the paper height does not exceed the line indicated inside of the guide.

• Do not use creased, folded, wrinkled or damp sheets of paper.

Make sure that a gap of 0.02" (0.04" or less in total) is left between the paper and the side guide for plain paper, and approx. 0.02" to

0.04" (approx. 0.04" to 0.08" in total) for thick paper. If the gap is insufficient, it could cause paper misfeeding.

A

33

1.BEFORE USING EQUIPMENT

8 Push the drawer straight into the equipment until it comes to a stop.

• Be sure to close the drawer securely and carefully.

1

Be careful not to let your fingers be caught when closing the drawer. This could injure you.

9

When the paper size is different from the one in the drawer, change the paper size indicator to match with the size of paper which has been set.

10

When the paper size is different from the one in the drawer, press the

[YES] button. When the paper is the same size as the one in the drawer, press the [NO] button. (When you press the [NO] button, you do not need to continue with step 11 and subsequent steps.)

This menu may not be displayed under a certain equipment setup. In this case, see the procedure in

! P.36

“Changing the setting of paper size” to change the paper size setting when a paper size different from the one

which had been placed in the drawer is set.

- Contact the administrator in your office when the display setting of this menu needs to be changed.

34

4.Setting Copy Paper (Cont.)

1

11 Press the paper size button corresponding to the paper that has been set in the drawer.

12 When you want to change the setting of the drawer for special uses

(

! P.38), press the paper type button.

13 Press the [ENTER] button.

35

1.BEFORE USING EQUIPMENT

Changing the setting of paper size

If the setting of the paper size registered in the equipment does not correspond to the one in the drawer, it could cause a paper jam. In this case, change the setting of the paper size according to the following procedure.

1 Press the [USER FUNCTIONS] button on the control panel.

1

2 Press the [USER] button on the touch panel to enter the user setting menu and then press the [DRAWER] button.

3 Press the drawer on the touch panel corresponding to the one in which the paper size has been set, and then press the button indicating the new one.

36

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement

Table of contents