Operator`s Manual for Basic Functions CX1145 MFP

Add to my manuals
341 Pages

advertisement

Operator`s Manual for Basic Functions CX1145 MFP | Manualzz

3.Bypass Copying (Cont.)

2

Bypass copying on standard size paper

Copying on LD, LT, LG and ST-R size paper

1 Place some sheets of paper with their copy side down on the bypass tray. Align the side guides to the paper length while holding A.

• The message “Ready for bypass feeding” appears.

• Rear side of the side guides of the bypass tray has an indicator for paper height. The height of the sheets must not exceed this indicator.

• When you use more than one sheet, fan the sheets well before setting them on the tray.

• Do not push the sheets into the entrance of the bypass feeder; this may cause a paper jam.

A

When the paper size is larger, draw out the three-stage paper holder. Raise B when you use LD or a larger size of paper.

B

2 Place the original(s).

3 Press the button of the same size as the one of the paper you have set on the tray.

• If the paper size is not specified here, copying may be slowed down.

59

2.HOW TO MAKE COPIES

4 Press the [MEDIA TYPE] button on the touch panel if the media type of the paper you have set on the tray is other than plain paper.

2

5 Press the button of the same media type as the one of the paper you have set on the tray, and then press the [ENTER] button on the touch panel.

• Set other copy modes as required.

• If a media type which is not same as the one you have set is selected here, this may cause a paper jam or significant image trouble.

6 Press the [START] button on the control panel.

When you copy on OHP films, remove the copied OHP films, which have exited on to the receiving tray one by one. When the films pile up, they may become curled and may not be projected properly.

60

3.Bypass Copying (Cont.)

2

Copying on standard size paper other than LD, LT, LG and ST-R

1 Place paper and original(s) by following step 1 and 2 in “Copying on

LD, LT, LG and ST-R size paper” (

! P.59).

2 Press the [OTHER SIZE] button on the touch panel.

3 Press the button of the same size as the one of the paper you have set on the tray.

E.g.: When COMP-size paper is set

4 Press the [OTHER] button for the media type.

• If the paper size is not specified here, copying may be slowed down.

61

2.HOW TO MAKE COPIES

5 Press the [MEDIA TYPE] button on the touch panel if the media type of the paper you have set on the tray is other than plain paper.

2

6 Press the button of the same media type as the one of the paper you have set on the tray, and then press the [ENTER] button on the touch panel.

E.g.: When Thick 1 paper is set

• Set other copy modes as required.

• If a media type which is not same as the one you have set is selected here, this may cause a paper jam or significant image trouble.

7 Press the [START] button on the control panel.

When you copy on OHP films, remove the copied OHP films, which have exited on to the receiving tray one by one. When the films pile up, they may become curled and may not be projected properly.

62

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement

Table of contents