Operator`s Manual for Basic Functions CX1145 MFP

Add to my manuals
341 Pages

advertisement

Operator`s Manual for Basic Functions CX1145 MFP | Manualzz

7. EDITING

Trimming / Masking

This function allows you to copy only the inside of the specified area on an original (trimming) or copy with the specified area masked (masking). Up to 4 rectangular areas can be specified on an original.

• Image editing is only available with standard-size originals.

• If the original and copy paper sizes are set incorrectly, the image in the specified range may not be copied correctly.

1. An example of trimming

2. An example of masking

1 2

1

Place paper in the drawer(s).

• When using this mode in bypass copying, be sure to specify the paper size (

! P.71 “1.Paper Selection”).

2 Press the [EDIT] button to enter the edit menu, and then press the

[EDITING] button.

5

3 Press the [TRIM] (or [MASK]) button.

138

7.EDITING (Cont.)

4 Place the original with its face up on the original glass.

• Set the original with its face up and bottom toward you and fit its top left corner against that of the original glass to align it with the original scales.

5

Do not place heavy objects (9 lb. or more) on the original glass and do not press on it with force. Breaking the glass could injure you.

5 Specify the area. Read the following 4 values of the left and top scales.

X1: Distance from the top left to the left edge of the specified area

X2: Distance from the top left to the right edge of the specified area

Y1: Distance from the top left to the upper edge of the specified area

Y2: Distance from the top left to the lower edge of the specified area

• The marks of the original scale have a 2 mm (0.08") pitch.

6 Enter the values read in step 5 for the specified area, and then press the [SET] button. Set 4 values in order.

• After the setting of 4 values is finished, the next edit area menu is displayed. Repeat steps 5 and 6 when you specify other areas. Up to 4 areas can be specified on an original.

• To correct the value which has been set, press the [RESET] button. Pressing it once makes the highlighted field move one position upward. Highlight the field in which you want to rectify the value, and then key in the correct one.

7 Press the [ENTER] button after specifying the area.

139

5.USING THE EDITING FUNCTIONS

8 Place the original(s) with its face down.

• Set the original with its face down and bottom toward you and fit its top left corner against that of the original glass.

• Select other copy modes as required.

9 Press the [START] button.

5

140

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement

Table of contents