9 Parameters. SEW MOVITRAC LTE-B

Add to my manuals
59 Pages

advertisement

9 Parameters. SEW MOVITRAC LTE-B | Manualzz

Parameters

Standard parameters

P6..

P60.

P600

9 Parameters

9.1

Standard parameters

Parameter Description

P-01 Max. speed limit

(Hz or rpm)

P-02

P-03

P-04

P-05

P-06

P-07

P-08

P-09

P-10

P-11

Min. speed limit

(Hz or rpm)

Acceleration ramp time (s)

Deceleration ramp time (s)

Voltage boost

Range

P-02 to 5

×

P-09

(max. 500 Hz)

0 – P-01 (max. 500 Hz)

0.0 – 600 s

0.0 – 600 s

Default

50.0 Hz

1)

0.0 Hz

5.0 s

Explanation

Maximum speed limit in Hz or rpm (see P-10)

Minimum speed limit in Hz or rpm (see P-10)

Stop mode select

Energy optimizer 0 Disabled

Motor rated voltage

Motor rated current

Motor rated frequency

Motor rated speed

0

1

2

Ramp to stop

Coast to stop

Ramp to stop (fast stop)

1 Enabled

0, 20 – 250 V

0, 20 – 500 V

5.0 s

0

0

230 V

400 V

2)

Acceleration ramp time from 0 to 50 Hz (fixed) in seconds.

Deceleration ramp time from 50 Hz (fixed) to standstill in seconds. If set to 0, then the fastest possible ramp time without trip is activated.

If the supply is lost and P-05 = 0, then the drive will try to continue running by reducing the speed of the load using the load as a generator.

If P-05 = 2, then the drive will ramp to stop using the P-24 deceleration ramp when mains supply is lost. Also activates constant power braking mode for normal braking.

When enabled, automatically reduces applied motor voltage on light load.

Rated (nameplate) voltage of the motor in volts.

The value is limited to 250 V for low voltage drives. Setting to 0 disables voltage compensation.

Rated (nameplate) current of the motor in amps. 25 – 100 % of drive current rating DR-Motor rating

25 – 500 Hz 50 Hz

1)

Rated (nameplate) frequency of the motor.

0 – 30000 rpm

0 – 20 % of max output voltage.

Resolution 0.1 %

• Size 1 = 20 %

• Size 2 = 15 %

• Size 3 = 10 %

0

Motor power dependent

When not set to 0 all speed-related parameters are displayed in rpm. Activates slip compensation when motor nameplate speed is set.

Applies an adjustable boost to the MOVITRAC

® voltage output at low speed to assist with starting

’sticky’ loads. For continuous applications at low speed use a force ventilated motor.

U

P-07

9

P-07

2

20 %

10 %

0 %

P-09 f

P-09

2

Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]

Operating Instructions – MOVITRAC® LTE-B

39

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals