13
OWNER’S MANUAL
Deck Input Channels
Two input channels, or buses, have nearly identical controls with the exception of the Source selectors.
Source Selector
DECK 1
BYPASS CLEAN FEED
sources:
•
A
Left Virtual Deck (USB stereo playback pair
1-2) from USB A.
SP-6 ASSIGN ON
4 6
OVER
• Also assigns the MIDI controls for the Left Deck
8
BACK
software and Deck 1 mixer to USB A.
0
LEVEL
10
• PH / CD 1 (THRU): Set to PH or CD on the rear panel.
• When selected in software, this input is available
SCROLL
LOOPS
HIGH
+6
signal or for audio recording. To select this control
Setup > PGM 1 and select “1”.
OFF
MIC
LOW
• PH / CD 2 (THRU): Set to PH or CD on the rear panel.
+6
• When selected in software, this input is available
FLEXFX
A
PH / CD
1 2
B
DECK 1
2
4
SOURCE
6
0
LEVEL
10
8
LEFT
PAN
RIGHT
LOW
FILTER
HIGH
FLEXFX
OFF
HIGH
+6
OFF
MID
+6
OFF
LOW
+6
2
4 6
8
DECK 2
A
PH / CD
3 4
B
0
LEVEL
10
SOURCE
OFF
HIGH
+6
OFF
MID
+6
OFF
LOW
+6
LEFT
PAN
RIGHT
LOW
FILTER
HIGH
FLEXFX
INSERT FILTER FLANGER PHASER ECHO ROBOT REVERB
•
•
B
Left Virtual Deck (USB stereo playback pair 1-2) from USB B.
BPM NUDGE START / STOP
Also assigns the MIDI controls for the Left Deck software and Deck 1 mixer to USB B.
SLIP
4000 ms
SAVE LOOP
TIME TAP
BEAT
•
•
A
Right Virtual Deck (USB stereo playback pair 3-4) from USB A.
Also assigns the MIDI controls for the Right Deck software and Deck 2 mixer to USB A.
• PH / CD 3 (THRU): Set to PH or CD with the rear panel switch.
•
AUX
6
A B
ON
2 3
CUE
8
•
PGM 1 and select “3”.
0 10
PH / CD 4 (THRU): Set to PH or CD with the rear panel switch.
•
LEVEL
CUE CUE CUE
When selected in software, this input is available on USB record 7-8 for use as the DVS control signal or for audio recording. To select this control source in Serato DJ: go to Setup > Audio > Deck Setup >
PGM 1 and select “4”.
LOW
FILTER
HIGH
•
B
Right Virtual Deck (USB stereo playback pair 3-4) from USB B.
• Also assigns the MIDI controls for the Left Deck software and Deck 2 mixer to USB B.
4
C
2
EXT. INSERT
4
0
DEPTH
10
5
D
6
8
MIX
4 6
2 8
0
MAIN
10
4 6
2
0 10
SESSION OUT
4 6
8
2 8
0 10
SESSION IN
4 6
2 8
0
BOOTH
10
SP-6 ASSIGN
MANUAL
SELECT
DECK 2
BACK
LOAD
SCROLL
LOOPS
AUTO
BEATS
IN
SYNC
LOOP
OUT
SYNC OFF
ROLL
LOOP
2
SLIP
SHIFT
PHONES
4 6
0
LEVEL
10
CUE
PAN
MAIN
SPLIT CUE
SAVE
8
Level
LEVEL controls adjust the input gain from off to +15 dB. Unity gain (no boost or cut) is at 12 o’clock.
Pan
Left / Right PAN controls adjust the balance of left and right signals. Left and right are equal at 12 o’clock .
Tone Controls
HIGH, MID and LOW full-cut isolator tone controls adjust the frequency response from off to +6 dB. Unity gain (no boost or cut) is at 12 o’clock.
SIXTY-TWO
OWNER’S MANUAL
DECK 1
MIC DECK 1 DECK 2 MIX DECK 2
Filter
BYPASS CLEAN FEED
A
PH / CD
1 2
B
4 6 4 6
A
PH / CD
3 4
B
4 6
The FILTER sweeps from Low-Pass to High-Pass. Set it to 12 o’clock for a flat “no-filter” response. Moving
2
SP-6 ASSIGN ON
4
8 2 8
LOW position progressively reduces high frequencies. Moving the filter toward the HIGH
SOURCE
0
LEVEL
10 0
LEVEL
10
SOURCE
2
0
MAIN
10
8
SP-6 ASSIGN
the mixer in the "Deck 1-2 Channel Options Menu" on page 23, or in the "Rane Drivers" on page 26.
LOAD
0
LEVEL
10
LOAD
used for mixing.
FlexFX
SCROLL
LOOPS
AUTO MANUAL
OFF
HIGH
+6
LEFT
PAN
LOOPS
2 8
The blue FLEXFX buttons assign an input to the FlexFX bus where internal, external analog or software
LOW
FILTER
RIGHT
HIGH
OFF
OFF
HIGH
MID
+6
+6
OFF
OFF
HIGH
MID
+6
+6
LEFT
PAN
RIGHT
LOW
FILTER
HIGH
0 10
SESSION OUT
4 6
0 10
SESSION IN
MANUAL
SCROLL
effects via USB may be inserted. Any combination of Deck 1, Deck 2, Mic or USB Aux can be assigned
with the option to insert internal effects, external analog effects or software effects via USB. See "FlexFX
2 8
SELECT
AUTO
BEATS
FLEXFX FLEXFX
FLEXFX
OFF
LOW
+6 OFF
LOW
+6 0
BOOTH
10
SYNC
LOOP
and
IN
CONTOUR controls on the front panel. See "Magnetic Fader Maintenance" on page 36.
IN LOOP
These faders use magnetic non-contact mechanisms with no noise and no bleed. Each fader has REVERSE
INSERT FILTER
PHASER ROBOT
SYNC OFF
ROLL OUT OUT ROLL
BPM NUDGE START / STOP
FLANGER +Fb
4 6
SAVE LOOP
hold. Use the
TIME TAP
BPM:120 * 1:1
LEVEL controls to stay out of the red.
4000 ms
ON
CUE
2
DEPTH
10
8
LOOP
SLIP
Each Deck channel has a mono meter to assist in setting levels. These meters are quasi-peak with peak
0
BEAT
SAVE
SHIFT SHIFT
1 2 3 4 5 CUES 1 2 3 4 5
Headphone Cue
CUE buttons assign a signal to the headphone monitor. Deck 1, Deck 2, USB Aux, and the
6
A B 1 2 3 SAMPLES 4 5 6 C D
PHONES
4 6
2 8
0
LEVEL
10
simultaneously pressing more than one Cue.
DECK 1
CUE
• The Headphone monitor provides stereo or mono split cue operation.
CUE
DECK 2
• When set for stereo operation ( SPLIT CUE dim), the Pan control pans between stereo
LOW
FILTER
HIGH
Cue and stereo Main Mix.
• When set for Split Cue operation ( SPLIT CUE bright), the Pan control pans between
CUE
PAN
MAIN
SPLIT CUE
• The Phones LEVEL control sets the volume to the headphone jacks.
• Headphone outputs are from ¼" and 3.5 mm jacks on the front panel. Both share the same mix.
14
SIXTY-TWO