- Computers & electronics
- Computer components
- System components
- Motherboards
- Rosch Computer
- i910GML-DCQIC6
- User manual
advertisement
i910GML-DCQIC6/ i915GM-DCQI
1.8.10 Primary IDE Connector (IDE1)
This connector is for an Ultra DMA 100/66 signal cable. The Ultra DMA 100/66 signal cable has three connectors: a blue connector for the primary IDE connector on the motherboard, a black connector for an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive), and a gray connector for an Ultra DMA 100/66 IDE master device (hard disk drive). If you install two hard disk drives, you must configure the second drive as a slave device by setting its jumper accordingly. Refer to the hard disk documentation for the jumper settings. z Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. z Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices. z Orient the red markings (usually zigzag) on the IDE ribbon cable to Pin 1.
40
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 15 Placement Direction
- 15 Screw Holes
- 17 Layout Content List
- 20 Installing the CPU
- 22 Installing the CPU Heatsink and Fan
- 24 Uninstalling the CPU Heatsink and Fan
- 25 DIMM Sockets Location
- 26 Memory Configurations
- 27 Installing a DDR2 DIMM
- 27 Removing a DDR2 DIMM
- 28 Installing an Expansion Card
- 28 Configuring an Expansion Card
- 29 Standard Interrupt Assignments
- 29 PCI Slots
- 30 Clear CMOS (CLRRTC1)
- 31 COM Port 1, 2 RI/+5V/+12V Selection (JCOMPWR1)
- 31 COM Port 3, 4 RI/+5V/+12V Selection (JCOMPWR2)
- 32 CPU VCC Voltage Select (VCCA_SEL1)
- 33 Rear Panel Connectors
- 35 Amplifier Connector (AMPJ1)
- 35 CPU Fan Connector (CPU_FAN1)
- 36 System Fan Connector (SYS_FAN1)
- 36 Serial Port Connector 3 (COM3)
- 37 Serial Port Connector 4 (COM4)
- 37 Front Headphone Connector (F_AUDIO1)
- 38 System Panel Connector (F_PANEL1)
- 39 USB 2.0 Connector (FRONT_USB1, FRONT_USB2)
- 40 Primary IDE Connector (IDE1)
- 41 ATX Power Connector (JATXPWR1)
- 42 LCD Inverter Connector (JBKLT1)
- 42 LVDS Connector (JLVDS1)
- 43 Digital I/O Connector (JDIO)
- 43 Serial ATA Connector 1 & 2 [Black] (SATA1, SATA2)