LampLinc V2 2456D3

LampLinc V2 2456D3

INSTEON LampLinc V2 Dimmer User’s Guide

HOW TO SET UP LAMPLINC DIMMER

Linking LampLinc Dimmer to an INSTEON Controller

1. Select your INSTEON Controller from the list below and follow the method shown to put it into

Linking Mode.

A. SwitchLinc

V2 Dimmer – Press and hold SwitchLinc V2 Dimmer’s Paddle

Top for 10 seconds, then release. To confirm that it is in Linking Mode,

SwitchLinc V2 Dimmer will flash the light that it is wired to once and begin blinking the top LED in its LED Bar.

B. ControLinc

V2 Tabletop Controller – Choose the ON/OFF Button Pair you want to use for controlling LampLinc Dimmer. Press and hold the ON Button of the pair for 10 seconds. To confirm that it is in Linking Mode, ControLinc

V2’s Status LED will begin blinking.

C. KeypadLinc

V2 – Choose the ON Button you want to use for controlling

LampLinc Dimmer. Press and hold the ON Button for 10 seconds. To confirm that it is in Linking Mode, KeypadLinc V2 will flash the light that it is wired to once and begin blinking the ON Button that you pushed.

D. Other INSTEON Controllers – See the INSTEON Controller’s User’s Guide.

2. Press and hold the black SET Button on LampLinc Dimmer for 3 seconds.

Both the lamp you are controlling and LampLinc Dimmer’s Status LED will blink to confirm linking.

Depending on the INSTEON Controller, you have about 4 minutes to perform this step before Linking

Mode times out automatically.

Page 6 of 21

INSTEON LampLinc V2 Dimmer User’s Guide

Unlinking LampLinc Dimmer from an INSTEON Controller

If you are no longer going to use a LampLinc Dimmer that has previously been linked to an INSTEON

Controller, it is very important that you unlink it, because otherwise the controller will retry any commands intended for the unused module, thus slowing down your system.

1. Select your INSTEON Controller from the list below and follow the method shown to put it into

Unlinking Mode.

A. SwitchLinc V2 Dimmer – Press and hold SwitchLinc V2 Dimmer’s Paddle

Top for 10 seconds TWICE. To confirm that it is in Unlinking Mode,

SwitchLinc V2 Dimmer will flash the light that it is wired to once for each paddle press and begin blinking the top LED in its LED Bar.

B. ControLinc

V2 Tabletop Controller – Press and hold the OFF Button of the ON/OFF Button Pair you used for controlling LampLinc Dimmer for 10 seconds. To confirm that it is in Unlinking Mode, ControLinc V2’s Status LED will begin blinking.

C. KeypadLinc

V2 – Press and hold for 10 seconds the ON Button you used for controlling LampLinc Dimmer, then press and hold the same ON Button for 10 seconds again. To confirm that it is in Unlinking Mode, KeypadLinc V2 will flash the light that it is wired to once and begin blinking the ON Button that you pushed.

D. Other INSTEON Controllers – See the INSTEON Controller’s User’s Guide.

2. Press and hold the black SET Button on LampLinc Dimmer for 3 seconds. Both the lamp you are controlling and LampLinc Dimmer’s Status LED will blink to confirm unlinking. Depending on the

INSTEON Controller, you have about 4 minutes to perform this step before Unlinking Mode times out automatically.

Page 7 of 21

Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement

Table of contents