SNMP—Status and community configuration
Port Status and Port Summary Statistics—Port and trunk configuration details, summary, and statistics
Trunk Configuration and Trunk Statistics—Trunk configuration details and flap count statistics
Flow Control and Storm Control Configuration—Enable/disable status
Auto DoS Features—Enable/disable status
Web Configuration—HTTP and HTTPS status and timeout settings
MAC Table—Address forwarding table and summary statistics
VLAN Configuration and VLAN Port Membership—Configured VLANs and membership details
Port Mirroring Configuration—Enable/disable status and source and destination port configuration
IGMP Status—Enable/disable information and statistics
LLDP and LLDP-MED Configuration—Global settings and per-port LLDP configuration and activity
Loop Protection Status— Per interface configuration and statistics
Spanning Tree Bridge and Interface Status—Global and per-port configuration and status
Green Features (EEE) Configuration—Global and per-port enable/disable status and power consumption data
PoE Configuration— On switches that support PoE, global and per-port configuration and schedule settings.
You can click Save As to save the Support File page content. The Support File page is saved as
HTML and is named support_file.html by default.
Locator
When you need to physically locate the switch, you can use this page to activate a blinking LED on the switch. When enabled, the LED blinks for 30 minutes before being automatically turned off by switch software. You can also use this page to disable the LED if the switch has been located.
To display the Locator page, click Diagnostics > Locator in the navigation pane.
Figure 143. Locator Page
Select Enabled and click Apply to cause the Locator LED on the switch to blink for 30 minutes. The
Locator System LED in the Device View is illuminated and blinks orange while this feature is active.
This feature is disabled by default (see
“System LEDs” on page 16
).
Note that this setting is not stored with the system configuration, so clearing the configuration will not change this value. If the switch reboots, this value is reset to Disabled.
Locator 197
