Peripheral Connections. Hikvision DS-9632NI-ST Series, DS-8616NI-ST Series, DS-8608NI-ST Series, DS-9608NI-ST Series, DS-7608NI-ST Series

Hikvision DS-7608NI-ST Series is an advanced surveillance NVR capable of recording and managing video footage from security cameras. It supports up to 8 SATA hard disks for massive storage capacity and features alarm and RS-485 connectivity for comprehensive security monitoring. With its user-friendly interface, remote access capabilities, and support for multiple cameras, the DS-7608NI-ST is ideal for securing homes, businesses, and other properties.

PDF

Document

Quick Operation Guide of DS-9600/8600/7600NI-ST Series NVR

GROUND

AC 100V ~ 240V

POWER

Ground (needs to be connected when NVR starts up).

AC 100V ~ 240V power supply.

Switch for turning on/off the device.

No. Item

1 VIDEO OUT

AUDIO OUT

AUDIO IN

RS-232 Interface

VGA

HDMI

USB

LAN Interface

RS-485 Interface

ALARM IN

ALARM OUT

10 Power Supply

11 Power Switch

Description

BNC connector for video output.

BNC connector for audio output.

BNC connector for audio input. (Also for voice talk)

Connector for RS-232 devices.

DB9 connector for VGA output. Display local video output and menu.

HDMI video output connector.

Connects USB disks and devices.

Connector for LAN (Local Area Network).

Connector for RS-485 devices. T+ and T- pins connect to R+ and R- pins of

PTZ receiver respectively.

Connector for alarm input.

Connector for alarm output.

12VDC power supply.

Switch for turning on/off the device.

Peripheral Connections

Connecting to Alarm Input / Output Device

The alarm input/output interface of the NVR is shown as below:

The alarm input is an open/closed relay. If the input is not an open/closed relay, follow the connection diagram below:

Quick Operation Guide of DS-9600/8600/7600NI-ST Series NVR

To connect to an AC/DC load, use the following diagram:

For DC load, JP4 can be used within the limit of 12V/1A safely. If the interface is connected to an AC load, JP4 should be left open. Use an external relay for safety (as shown in the figure above).

There are 4 jumpers (JP4, JP5, JP6, and JP7) on the motherboard, each corresponding with one alarm output. By default, jumpers are connected. To connect an AC load, jumpers should be removed.

Note:

An external relay is needed to prevent electric shock when connecting to an AC load.

Alarm Connection

To connect alarm devices to the NVR:

1. Disconnect pluggable block from the ALARM IN /ALARM OUT terminal block.

2. Unfasten stop screws from the pluggable block, insert signal cables into slots and fasten stop screws. Ensure signal cables are in tight.

3. Connect pluggable block back into terminal block.

RS-485 Connection

In this manual we take the RS-485 connection of the DS-8600NI-ST as an example.

Hello! I am an AI chatbot specifically trained to assist you with the Hikvision DS-9632NI-ST Series Quick Operation Manual. I have thoroughly reviewed the document and can help you locate the exact information you need or explain the content in clear and simple terms. Whether you’re looking for guidance on specific features, troubleshooting steps, or general usage, feel free to ask your questions. The more details you provide about your concerns or needs, the more accurately and effectively I can assist you!