Setup of Process data for IO-Link Devices. Festo CTEU-EP, CPX-FB36, CPX-CTEL-LK
Add to My manuals30 Pages
The CTEU-EP, CPX-FB36, and CPX-CTEL-LK are Festo products that support the ability to add 3rd party IO-Link devices. These devices can be used to control various types of sensors and actuators, such as RFID readers, light stacks, and other IO-link devices. The application note provides detailed information on how to configure and use these products, including information on how to validate the IO-link devices, how to read diagnostics events, and how to set IO-link parameters.
advertisement
3
Setup of Process data for IO-Link Devices
3 Setup of Process data for IO-Link Devices
Follow the instructions from the standard manuals for CPX-FB36 or CTEU-EP for the basic setup of the I/O-Devices in your Engineering Software. The following examples are showing the typical integration in the “Studio
5000” Engineering Software provided by Rockwell Automation.
3.1 Typical Configuration of CPX-FB36 with CPX-CTEL-LK
Note
There must be at least one CPX-CTEL-LK module in the CPX terminal
• The I/O-size of the CPX-CTEL-LK module has to be large enough to hold the data of the connected
IO-Link devices. Refer to the CPX-CTEL-LK manual for details on the corresponding settings of the
DIL switches
Seite 6 von 30 Application Note – EtherNet/IP IO-Link Integration – 1.30
advertisement
Key Features
- Supports IO-Link devices
- Provides diagnostics for IO-Link devices
- Allows parameterization of IO-Link devices
- Integrates with Festo EtherNet/IP products
- Provides detailed documentation for setup and configuration
- Supports a range of 3rd party IO-Link devices