2.3. HARDWARE INSTALLATION. Gigabyte GV-R92128TE

Add to my manuals
32 Pages

advertisement

2.3. HARDWARE INSTALLATION. Gigabyte GV-R92128TE | Manualzz

2.3. HARDWARE INSTALLATION

Installing your graphics card.

Now that you have prepared your computer, you are ready to install your graphics accelerator card.

To install your graphics accelerator card:

1. Power off the computer and monitor, then disconnect the display cable from the back of your computer.

2. Remove the computer cover. If necessary, consult your computer's manual for help in removing the cover.

3. Remove any existing graphics card from your computer.

Or, if your computer has any on-board graphics capability, you may need to disable it on the motherboard. For more information, see your computer's documentation.

- 7 -

R92128TE_101.p65

7

Hardware Installation

2003/6/30, 下午 04:11

4. Locate the AGP slot. If necessary, remove the metal cover from this slot; then align your graphics card with the AGP slot, and press it in firmly until the card is fully eated.

5. Replace the screw to fasten the card in place, and replace the computer cover.

GV-R92128TE graphics card AGP slot

6. Plug the display cable into your card; then turn on the computer and monitor. If your graphics card came with a DVI connector, you can connect a flat panel display to the appropriate connector, as shown below...

To VGA MONITOR

To TV or VCR

You are now ready to proceed with the installation of the graphics card driver. For detailed instructions, select your operating system from the list below.

GV-R92128TE Graphics Accelerator - 8 -

R92128TE_101.p65

8 2003/6/30, 下午 04:11

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals