Camera-Audio & P/T/Z. ERNITEC DigiOpG2 EDNS3000 Series

Add to My manuals
51 Pages

advertisement

Camera-Audio & P/T/Z. ERNITEC DigiOpG2 EDNS3000 Series | Manualzz

DigiOpG2

6.8

Camera-Audio & P/T/Z

Set the camera audio and P/T/Z environment.

Digital Video Recorder

6.8.1.

Audio

Select whether to use audio recording. Select On/Off in the audio tap for each camera.

Note

Use amplifier-equipped devices when connecting to the audio input/output device.

6.8.2.

Audio-CH

Select the audio channel to use among the 4 audio input channels.

6.8.3.

P/T/Z Address

Set the P/T/Z driver address of the connected camera.

Check the below items for proper P/T/Z operation.

1.

Check if the protocol of all P/T/Z controllers connected to the system is in accordance.

2.

Check if the communication setting including baud rate of all P/T/Z controllers is in accordance with the assigned value for that P/T/Z protocol.

3.

Check if the address of all controllers is in accordance with the controller address assigned in the setting menu for that channel.

4.

Check if the power of the P/T/Z controller is turned on.

5.

Check if wiring to P/T/Z controllers is correct.

Page 40

3040-00052

advertisement

Related manuals