OPERATION WITH THE REMOTE CONTROL UNIT. Sanyo XS1271

01_XS1872_EN.fm Page 9 Thursday, September 25, 2008 8:31 PM

OPERATION WITH THE REMOTE CONTROL UNIT

1. Operation

STEP 2

2. Adjusting the Fan Speed

A. Automatic fan speed

Simply set the FAN SPEED selector button to the position.

This automatically sets the best fan speed for the room temperature.

B. Manual fan speed

If you want to adjust fan speed manually during operation, just set the FAN SPEED selector button as desired. [ ,

, or ]

3. Fan Only

STEP 3

STEP 2

STEP 4

STEP 5

STEP 1

NOTE

Check that the circuit breaker on the power panel is turned on.

Press the setting buttons as described below and change the settings as desired.

STEP 1

Press the MODE selector button and select the desired mode.

For dehumidifying operation

For cooling operation

For fan only operation

→

→

→

STEP 2

To start the air conditioner, press the ON/

OFF operation button.

STEP 3

Press the TEMP. setting buttons to change the temperature setting to the desired temperature.

Adjustable temperature range:

30 °C max.

16 °C min.

or 86 °F max.

60 °F min.

NOTE

STEP 4

Set the FAN SPEED selector button to the setting you want.

STEP 5

Press the FLAP button and set the airflow direction as desired.

(Refer to “ADJUSTING THE AIRFLOW

DIRECTION” on page 12.)

To stop the air conditioner, press the ON/OFF operation button again.

• Choose the best position in the room for the remote control unit, which also acts as the sensor for room comfort and transmits the operating instructions.

Once you’ve found this best position, always keep the remote control unit there.

• This appliance has a built-in 5-minute time delay circuit to ensure reliable operation. When the operation button is pressed, the compressor will start running within three minutes. In the event of power failure, the unit will stop.

STEP 3 STEP 1

If you want to circulate air without any temperature control, follow these steps:

STEP 1

Press the MODE selector button to switch to the fan mode .

STEP 2

Press the ON/OFF operation button.

STEP 3

Press the FAN SPEED selector button to select the fan speed of your choice ( ,

or ).

OI-108-9-EG 9