9. The brush circuit breaker will trip if the brush is obstructed. To reset the circuit breaker, unplug the power cord, remove the obstruction and reset the
2.5 amp circuit breaker button (Figure 18). If the circuit breaker does not reset immediately, allow the motor to cool.
FOR SAFETY: Before removing obstruction from brush unplug power cord from wall outlet.
OPERATION
EN
AFTER EACH USE
1. Wipe clean the power cord and inspect it for damage (Figure 20). Wrap power cord around handle and cord hook when not in use (Figure 21).
FIG. 18
10. When transporting machine, raise the scrub head to the transport position (Figure 19).
FIG. 20 FIG. 21
WARNING: Electrical Hazard, Do Not Operate
With Damaged Power Cord.
If the power cord is damaged or broken, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
2. Empty the recovery and solution tanks and thoroughly rinse with clean water (Figure 22).
FIG. 19
FOR SAFETY: When transporting machine, do not wheel up or down stairs.
MACHINE MAINTENANCE
To keep the machine in good working condition, simply follow the machine’s maintenance procedures.
FOR SAFETY: Before performing maintenance procedures turn off machine and unplug power cord from wall outlet.
ATTENTION: Contact an Authorized Service
Center for machine repairs.
FIG. 22
3. Clean the vacuum shut- off float (Figure 23) and the vacuum intake screen of any debris buildup
(Figure 24).
FIG. 23 FIG. 24
Tennant T1 (03- 08)
9
EN
OPERATION
4. Clean the solution hose screen (Figure 25).
7. Clean the squeegee blades of any debris (Figure
28). Replace the blades if worn or damaged.
FOR SAFETY: Before tipping machine back, unplug power cord from wall outlet.
FIG. 25
5. Remove and clean the brush (Figure 26). Replace brush if worn.
FIG. 28
To remove the squeegee blades, lift the blade retainer clip and pull the blade from the channel
(Figure 29).
When replacing blades, install the red blades to the inside channels and the gray blades to the outside channels, ribs facing outwards.
NOTE: The red and gray blade rails are designed to match up with the appropriate channel to prevent improper blade installation.
FIG. 26
6. Clean the underside of the scrub head (Figure 27).
FOR SAFETY: Before tipping machine back, unplug power cord from wall outlet.
FIG. 29
8. Clean the machine with an all purpose cleaner and damp cloth (Figure 30).
FIG. 27
FIG. 30
10
Tennant T1 (03- 08)