How to Install Your veloCD ReWRITER - diagram. TDK Velocd

Add to My manuals
35 Pages

advertisement

How to Install Your veloCD ReWRITER - diagram. TDK Velocd | Manualzz

Connected as master Connected as slave

Primary

IDE port

Connect veloCD drive as master

Connect as slave

Secondary

IDE port

Connected as master

Connected as slave

Primary

IDE port

Connect veloCD drive as master

Secondary

IDE port

Connected as master

Primary

IDE port

Connect veloCD drive as master

Secondary

IDE port

Set veloCD’s jumper to:

CS S M

Set veloCD’s jumper to:

CS S M

Set veloCD’s jumper to:

CS S M

NOTE: For best performance, connect the veloCD to the IDE port that is not connected to the hard drive or to a CD-ROM drive. In most cases, connect the veloCD to the secondary IDE port as a master.

NOTE: For best results, set the veloCD to be the master, if possible. Enable DMA settings on your system to achieve maximum writing speed.

SECTION 2 : Installing Your veloCD ReWRITER

7

advertisement

Related manuals