Installing a hard disk drive. Asus T2-R

Add to my manuals
94 Pages

advertisement

Installing a hard disk drive. Asus T2-R | Manualzz

2.9

Installing a hard disk drive

The system supports one UltraATA133 IDE hard disk drive (HDD).

To install a hard disk drive:

1.

Locate the HDD metal tray flathead lock screw on the other side of the chassis.

2.

Remove the flat head screw using a Philips screw driver.

Keep the screw for later use.

1

2

3.

Slide the HDD metal tray outward until its slots are released from the tray locks.

Tray locks

3

Lock slots

Tray locks

4.

Place a hard disk drive on the metal tray with its bottom on the open side of the tray. Align the

HDD and metal tray screw holes.

5.

Secure the HDD with four screws.

5

4

5

Configure your hard disk drive as Master device before connecting the

IDE cable and power plug. Refer to the HDD documentation on how to set the drive as Master device.

ASUS Terminator 2 barebone system 31

6.

Re-install the metal tray and the

HDD by sliding it to the tray hooks.

7.

Secure the HDD metal tray with the flat head screw you earlier removed.

7

8.

Connect one end of the 40-pin

IDE cable to the IDE connector on the drive.

9.

Connect a 4-pin power plug from the power supply unit to the HDD power connector.

10. Connect the other end of the

IDE ribbon cable to the primary

IDE connector (blue connector labeled PRI_IDE) on the motherboard. See page 53 for the location of the primary IDE connector.

6

8

9

32 Chapter 2: Basic installation

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement

Table of contents