Check Tire Pressures. Exmark LAZER Z LZX940KC726, LAZER Z LZX980KC606, LAZER Z LZX801KA606SS, LAZER Z LZX980KC726, LAZER Z LZX680KC486, LAZER Z X-SERIES Operators, LAZER Z LZX801KA606, LAZER Z LZX740KC606CA, LAZER Z LZX740KC526, LAZER Z LZX749EKC606

Add to my manuals
64 Pages

advertisement

Check Tire Pressures. Exmark LAZER Z LZX940KC726, LAZER Z LZX980KC606, LAZER Z LZX801KA606SS, LAZER Z LZX980KC726, LAZER Z LZX680KC486, LAZER Z X-SERIES Operators, LAZER Z LZX801KA606, LAZER Z LZX740KC606CA, LAZER Z LZX740KC526, LAZER Z LZX749EKC606 | Manualzz

Maintenance

5. Wipe the dipstick clean and re-insert the cap back into the hydro. Lightly tighten the cap.

6. Remove the cap again and check the level of the

oil on the dipstick. See Figure 24 for oil levels.

2. Remove left and right belt shields on deck and lift up floor pan to inspect deck drive belt.

3. Check under machine to inspect the pump drive belt.

Note: No adjustments are required for belt tension.

1.

Full

Figure 24

2.

Add

Note: The oil level on the dipstick will be incorrect if the oil is checked when the unit is hot.

7. If the dipstick oil level is at the “add” mark add

Exmark Premium Hydro oil.

8. Replace hydraulic reservoir cap and tighten until snug. Do Not overtighten.

Lubricate Grease Fittings

Note: See chart for service intervals.

1. Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

2. Lubricate fittings with one to two pumps of

NGLI grade #2 multi-purpose gun grease.

Refer to the following chart for fitting locations and lubrication schedule.

Lubrication Chart

Fitting

Locations

1. Deck and

Pump Idler

Pivots

2. Front

Caster

Pivots

Initial

Pumps

1

*0

Number of

Places

2

2

Service

Interval

Yearly

*Yearly

* See step 3 for special lubrication instructions on

the front caster pivots.

Check Tire Pressures

Service Interval: Every 50 hours

1. Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

2. Check tire pressure in drive tires.

3. Inflate drive tires to 13 psi (90 kPa).

4. Semi-pneumatic caster tires Do Not need to be inflated.

Note: Do Not add any type of tire liner or foam

fill material to the tires. Excessive loads created by foam filled tires may cause failures to the hydro drive system, frame, and other components. Foam filling tires will void the warranty.

Check Condition Of Belts

Service Interval: Every 50 hours

1. Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

3. Lubricate front caster pivots once a year. Remove hex plug and cap. Thread grease zerk in hole and pump with grease until it oozes out around top bearing. Remove grease zerk and thread plug back in. Place cap back on.

36

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals