Motion Control Damper Adjustment. Exmark LAZER Z LZX940KC726, LAZER Z LZX980KC606, LAZER Z LZX801KA606SS, LAZER Z LZX980KC726, LAZER Z LZX680KC486, LAZER Z X-SERIES Operators, LAZER Z LZX801KA606, LAZER Z LZX740KC606CA, LAZER Z LZX740KC526, LAZER Z LZX749EKC606

Add to my manuals
64 Pages

advertisement

Motion Control Damper Adjustment. Exmark LAZER Z LZX940KC726, LAZER Z LZX980KC606, LAZER Z LZX801KA606SS, LAZER Z LZX980KC726, LAZER Z LZX680KC486, LAZER Z X-SERIES Operators, LAZER Z LZX801KA606, LAZER Z LZX740KC606CA, LAZER Z LZX740KC526, LAZER Z LZX749EKC606 | Manualzz

Maintenance

Motion Control Neutral Lock

Pivot Adjustment

The flanged nut can be adjusted to obtain a more

desired motion control lever resistance (Figure 40).

Figure 38

1.

Double nuts

8. Shut off unit. Remove jumper wire from wire harness and plug connector into seat switch.

9. Remove the jack stands.

10. Raise the deck and re-install the height of cut pin.

11. Check that the machine does not creep in neutral with the park brakes disengaged.

Motion Control Damper

Adjustment

The top damper mounting bolt can be adjusted to obtain a more desired motion control lever resistance.

See Figure 39 for mounting options.

1.

Flanged nut

Figure 40

2.

Jam nut

1. Loosen the jam nut.

2. Tighten or loosen the flanged nut to the desired feel.

For more resistance, tighten the flanged nut.

For less resistance, loosen the flanged nut

3. Tighten jam nut.

Motion Control Handle

Adjustment

Adjusting the height:

The motion control levers can be adjusted higher or lower for maximum operator comfort.

1. Remove the two bolts holding the control lever to

the control arm shaft (Figure 41).

Figure 39

RH Motion Control Shown

1.

Torque nyloc nut to 200 in-lb (16.7 ft-lb). Bolt must protrude past end of nyloc nut after torque. A T-40 Torx bit will be necessary to hold the stud from turning.

2.

Most resistance (firmest feel)

3.

Damper

4.

Medium resistance (medium feel)

5.

Least resistance (softest feel)

46

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals