Adjustment. Exmark LAZER Z LZX940KC726, LAZER Z LZX980KC606, LAZER Z LZX801KA606SS, LAZER Z LZX980KC726, LAZER Z LZX680KC486, LAZER Z X-SERIES Operators, LAZER Z LZX801KA606, LAZER Z LZX740KC606CA, LAZER Z LZX740KC526, LAZER Z LZX749EKC606

Add to my manuals
64 Pages

advertisement

Adjustment. Exmark LAZER Z LZX940KC726, LAZER Z LZX980KC606, LAZER Z LZX801KA606SS, LAZER Z LZX980KC726, LAZER Z LZX680KC486, LAZER Z X-SERIES Operators, LAZER Z LZX801KA606, LAZER Z LZX740KC606CA, LAZER Z LZX740KC526, LAZER Z LZX749EKC606 | Manualzz

Maintenance

1.

Bolts

2.

Control lever

3.

Control arm shaft

Figure 41

4.

Nuts

5.

Slotted holes

1.

Screw

2.

Cover plate

Figure 42

RH Motion Control Shown

3.

Motion control lever

2. Move the control lever to the next set of holes.

Secure the lever with the two bolts.

3. Repeat the adjustment for the opposite control lever.

Adjusting the Tilt

The motion control levers can be tilted fore or aft for maximum operator comfort.

1. Loosen the upper bolt holding the control lever to the control arm shaft.

2. Loosen the lower bolt just enough to pivot the

control lever fore or aft Figure 41. Tighten both

bolts to secure the control in the new position.

3. Repeat the adjustment for the opposite control lever.

Caster Pivot Bearings

Pre-Load Adjustment

Remove dust cap from caster and tighten nyloc nut until washers are flat and back off 1/4 of a turn to properly set the pre-load on the bearings. If disassembled, make sure the spring disc washers are

reinstalled as shown in Figure 43.

Motion Control Full Forward

Tracking Adjustment

If the machine travels or pulls to one side when the motion control levers are in the full forward position, adjust the cover plates.

1. Loosen the screws on a cover plate (see Figure 42).

2. Slide the cover plate backward or forward to adjust the travel of the lever and tighten the screws.

3. Drive the machine and check the full forward tracking.

4. Repeat steps 1 through 3 until desired tracking

is obtained.

1.

Spring disc washers

Figure 43

47

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals