3com 7000
Manuals and User Guides for 3com 7000. We found 2 manuals for free downloads quick guide, User Guide
Below you will find brief information for AccessBuilder 7000 BRI Bridge/Router, AccessBuilder 7000 PRI Bridge/Router. These modules are installed and configured in the same way and provide full LAN-to-LAN connectivity using ISDN or leased lines. The Bridge/Router Module can connect to geographically separate LAN workgroups, remote office users, to central computing facilities. It has two ports to connect to leased line WAN connections, also available from your telephone carrier organization. Typically, the Bridge/Router module is used to interconnect LANs running protocols such as Transmission Control Protocol/Internet Protocol (TCP/IP) or Novell Internetwork Packet Exchange (IPX).
Key Features
Easy to install, configure and support
Supports ISDN and Leased Line connections
Full IP and IPX Routing
Protocol Transparent bridging
Data packet filtering for network security
NetWare protocol spoofing
Data compression
Scalable Router Clustering (SRC)
Remote and local management
Flash erasable programmable read-only memory (EPROM)
Pages: 150 3com 7000 quick guide
Brand: 3com Category: Networking Size: 1 MB
Languages: English
Table of contents
Open manualOther manuals and documents
Frequently Answers and Questions
What is the maximum bandwidth of the Bridge/Router Module?
The maximum bandwidth of the Bridge/Router Module is 2 Mbps. If you have a single leased-line link running at 2 Mbps connected to a WAN port, you must disable the ISDN ports and the second WAN port.
How many ISDN channels can the PRI Bridge/Router Module support?
The PRI Bridge/Router Module supports up to eight ISDN channels. However, if you use a WAN port, one less ISDN channel can be supported. If both WAN ports are used, a maximum of six ISDN channels can be supported by the module.
What is the purpose of the Manager port?
The Manager port enables a management PC or terminal to be connected to the module using the 9-pin D-type to RJ11 Serial Manager cable supplied with the unit. The port provides VT100 terminal emulation, running at 9600 bps. You also need a proprietary communications software package such as Windows ‘Terminal’ to communicate with the module’s management system.
advertisement