1. manualzz.com
  2. computers & electronics
  3. networking

ADTRAN Series E1/FE1 or E1/FE1 with G.703 Drop

Manuals and User Guides for ADTRAN Series E1/FE1 or E1/FE1 with G.703 Drop. We found 1 manuals for free downloads Manual

Below you will find brief information for NetVanta Series E1/FE1 or E1/FE1 with G.703 Drop. This guide provides step-by-step instructions for configuring a NetVanta Series E1/FE1 or E1/FE1 with G.703 Drop for use with either a frame-relay or PPP connection to a corporate router. Use the configuration scripts that are included on the ADTRAN OS System Documentation CD for help in configuring your device.

Key Features

  • Frame-Relay and PPP support
  • E1 and G.703 network interface support
  • TDM group creation for data and voice
  • Cross-connect configuration
  • Static and default route configuration
  • Telnet access and password configuration
  • Configuration saving to memory

Pages: 7 ADTRAN Series E1/FE1 or E1/FE1 with G.703 Drop Manual

Brand: ADTRAN Category: Networking Size: 172 KB

Languages: English

Open manual

Frequently Answers and Questions

How do I connect a VT100 terminal to the NetVanta?
Connect a VT100 terminal to the NetVanta CONSOLE port using a DB-9 (male) to DB-9 (female) straight-through serial cable. Configure the COM port with the following parameters: Data Rate: 9600, Data Bits: 8, Parity Bits: None, Stop Bits: 1, Flow Control: None.
What is the default password for accessing the NetVanta via Telnet?
The default password for accessing the NetVanta via Telnet is "password" (all lower-case). For security purposes, you should change this password to something unique.
How do I save my configuration changes to the NetVanta?
To save your configuration changes to the NetVanta, use the following command at the (config)# prompt: copy running-config startup-config.
What is the difference between a frame-relay and a PPP connection?
Frame-relay is a packet-switching technology that provides a virtual circuit connection between devices. PPP (Point-to-Point Protocol) is a protocol used to establish a dedicated point-to-point connection between two devices.
How do I configure the Ethernet port on the NetVanta?
At the (config)# prompt, enter interface eth 0/1 to access the configuration parameters for the Ethernet port. Enter ip address 10.10.20.7 255.255.255.0 to assign an IP address to the Ethernet port using a 24-bit subnet mask. Enter no shutdown to activate the interface to pass data.

advertisement