1. manualzz.com
  2. home
  3. Do-It-Yourself tools
  4. power tools

Baldor MicroFlex e100

Manuals and User Guides for Baldor MicroFlex e100. We found 2 manuals for free downloads Installation manual, Specification

Below you will find brief information for Servo Drive MicroFlex e100. This manual describes the basic installation of the MicroFlex e100, providing a flexible and powerful motion control solution for rotary and linear motors. The manual covers mechanical and electrical installation, including connecting the AC power supply, 24 VDC control circuit supply, motor, regeneration resistor, and feedback device.

Key Features

  • Single axis AC brushless drive
  • Range of models with continuous current ratings of 3A, 6A or 9A.
  • Direct connection to 115VAC or 230VAC single-phase or 230VAC three-phase supplies
  • Universal feedback interface
  • Position, velocity and current control
  • Auto-tuning wizard (including position loop)
  • 3 optically isolated general purpose digital inputs
  • 1 optically isolated drive enable input
  • 1 optically isolated general purpose digital output
  • 1 optically isolated digital output to indicate error conditions

Pages: 172 Baldor MicroFlex e100 Installation manual

Brand: Baldor Category: Power tools Size: 2 MB

Languages: English

Open manual

Other manuals and documents

27 Pages

Specification

Languages: English

Frequently Answers and Questions

What are the required power sources for the MicroFlex e100?
A 115 - 230 VAC power source (IEC1010 over-voltage category III or less) is required, which can be single-phase or three-phase. A 24 VDC control circuit supply must be a regulated power supply with a continuous current supply capability of 1 A (4 A power on surge).
What hardware is required for the basic installation?
You will need a 24 VDC power supply, an AC power supply filter, the motor, a motor power cable, a feedback cable, a USB cable, and optionally a regeneration resistor (Dynamic Brake) and a cooling fan.
Are there any special considerations for the mechanical installation?
The MicroFlex e100 must be installed indoors, permanently fixed, and located in a clean, dry environment with a pollution degree not exceeding 2 according to IEC664. It should be installed so that it can only be accessed by service personnel using tools. The maximum suggested operating altitude is 1000 m (3300 ft).
What is the purpose of the regeneration resistor?
A regeneration resistor (Dynamic Brake) helps to dissipate energy generated by the motor when it is decelerating. Without it, the drive might produce an overvoltage fault.
What types of feedback devices are supported by the MicroFlex e100?
The MicroFlex e100 supports incremental encoder, BiSS, SSI, EnDat, or SinCos feedback.
What types of motors can be used with the MicroFlex e100?
The MicroFlex e100 can operate with a large range of brushless rotary and linear servo motors, as well as induction motors using closed-loop vector control.
What is the purpose of the USB port?
The USB port allows you to connect the MicroFlex e100 to a PC for configuration and commissioning using the Mint WorkBench software.

advertisement