1658 Manuals

Bissell 1009 AeroSwift

Manuals and User Guides for Bissell 1009 AeroSwift. We found 1 manuals for free downloads User Guide

Below you will find brief information for vacuum cleaner 1009 AeroSwift. The 1009 AeroSwift is a powerful and versatile vacuum cleaner that is perfect for cleaning both carpets and hard floors. It features a TurboBrushTM tool for cleaning upholstery, stairs, and other hard-to-reach areas. A combination dusting/upholstery brush for dusting delicate surfaces and cleaning upholstery. The vacuum cleaner also comes with a crevice tool for cleaning in tight spaces and an extension wand for reaching high areas. The 1009 AeroSwift is easy to assemble and use, and its lightweight design makes it easy to maneuver around your home. It has 5 height adjustments to match your cleaning needs.

Key Features

TurboBrushTM tool
combination dusting/upholstery brush
crevice tool
extension wand
Lightweight design
5 height adjustments

Pages: 16 Bissell 1009 AeroSwift User Guide

Brand: Bissell Category: Vacuum cleaners Size: 2 MB

Languages: English, French

Open manual

Frequently Answers and Questions

What kind of filters does the vacuum cleaner have?

The vacuum cleaner comes with a standard foam filter (yellow) and a separate Febreze® foam filter (black) that can be replaced to eliminate odors. Both filters are washable.

How do I clean the upper tank and inner cyclone?

Empty the dirt bin, remove the upper tank, and wipe out the inside of the upper tank and inner cyclone with a damp cloth moistened with water or a mild cleaning solution. The inner cyclone can be washed using a mild detergent; it must be completely dry before reassembling or damage to your unit may result. Do not clean in dishwasher.

How do I check for clogs in the vacuum cleaner?

Check for clogs in the hose by removing the hose from the upper hose inlet and base. Also check for clogs in the base hose connector. If you notice a clog, remove the extension tools from the storage post and remove the screw in the lower hose base connector with a Phillips screwdriver. Slide the lower hose collar up out of the tabs and straighten the hose to unclog. Use a long object to reach in and unclog. Connect the lower hose collar by lining up the tab grooves with the base and pushing down. Replace the screw back into the base to secure.

How do I check the rotating floor brush and drive belt?

Recline the handle into lowest position and turn the vacuum over so bottom side is facing up. Remove dirt bin to avoid any damage to the bin and easier access to the floor brush. Remove the 3 screws in the brush cover using a Phillips screwdriver. Lift up and remove the brush cover to access brush roll. Grasp the rotating brush at both ends at lift out. Clear strings, hair and other debris from the brush, brush cover, motor pulley and drive belt areas. Check the drive belt for wear, cuts or stressed areas. If you see no visible damage, keep the belt connected to motor pulley. If belt is damaged, refer to replace drive belt section. With drive belt connected to motor pulley, pull the belt over the brush roll and position the floor brush into the brush cover ends. Rotate the brush end opposite of the belt to line up with the brush cover tab. The brush end closest to the belt will slide in the tab without needing to rotate. Replace brush cover and secure with the 3 screws.