Bosch B920

Manuals and User Guides for Bosch B920. We found 2 manuals for free downloads installation Guide, Manual

Below you will find brief information for keypad B920. The B920 keypad is an SDI2 bus compatible device that displays two-line system messages, and user adjustable options such as volume and display brightness. The keypad connects to the SDI2 bus on the control panel using terminal wiring. The keypad can be programmed locally (from the control panel keypad) or remotely through Remote Programming Software (RPS).

Key Features

  • SDI2 Bus compatible
  • Two-line LCD display
  • User adjustable options
  • Remote programming capability
  • Status indicators
  • Audible tones
  • Supervised by control panel
  • Firmware version display
  • UL and CSA certified

Pages: 2 Bosch B920 installation Guide

Brand: Bosch Category: Fire protection Size: 309 KB

Languages: English

Open manual

Other manuals and documents

40 Pages

Manual

Languages: English

Frequently Answers and Questions

How do I set the address switches on the B920 keypad?
Use a slotted screwdriver to set the address switches according to the control panel configuration. Each keypad needs a unique address. For addresses 1 through 9, set the tens switch to 0. Refer to Figure 2.4 for the address switch setting for address 1.
How do I wire the B920 keypad to the control panel?
Use the control panel terminals labeled R, Y, G, B (PWR, A, B, COM) and connect them to the keypad terminals labeled R, Y, G, B. Refer to Figure 3.1. You can connect keypads to the SDI2 data bus by parallel wire run from the control panel to each keypad, wire from keypad to keypad, or a combination of the two techniques. Refer to Figure 3.2.
How do I adjust the display brightness on the B920 keypad?
Press [MENU] to open the Main menu, then use [NEXT] to go to the Press 5 for Settings Menu option, or simply press [5]. Then, use [NEXT] to go to the Press 4 for Keypad Config option, or simply press [4]. Press [1] to adjust the brightness and use [PREV] or [NEXT] to adjust the brightness level. The changes apply immediately. Press [ESC] to exit the menu.

advertisement