Carrier 07D
Manuals and User Guides for Carrier 07D. We found 1 manuals for free downloads Service Instructions
Below you will find brief information for Compressors and Condensing Units 06D, Compressors and Condensing Units 07D. These hermetic, water-cooled units are designed for efficient cooling. Installation, start-up, and service instructions are provided, including details on electrical connections, refrigerant charging, safety precautions, and troubleshooting. The units feature capacity control and safety switches for reliable operation.
Key Features
Hermetic and water-cooled design
Capacity control (suction cutoff type)
Multiple safety switches (high-pressure, low-pressure, oil pressure)
Detailed service and maintenance instructions
Factory-wired for single-pumpout control
Pages: 20 Carrier 07D Service Instructions
Brand: Carrier Category: Industrial & lab equipment Size: 741 KB
Languages: English
Open manualFrequently Answers and Questions
How do I check the oil level in the compressor?
Check the oil level in the compressor sight glass after 15 to 20 minutes of operation. If low, add Carrier-approved oil.
What is the function of the oil pressure switch?
The oil pressure switch protects against damage from loss of oil or oil pressure during start-up. It has a time delay of approximately 45 seconds.
How do I adjust the capacity control set point?
Refer to Figure 7. Turn the adjustment nut clockwise to its bottom stop (86 psig). Turning counterclockwise decreases the set point by 7.2 psi per full turn.
What precautions should be taken when working on the equipment?
Observe precautions in the literature, tags, stickers, and labels. Follow all safety codes. Wear safety glasses and gloves. Ensure power is shut off before servicing.
How often should the condenser tubes be cleaned?
At least once a year, or more often if the water is contaminated. Chemical cleaning may be necessary for hard scale.
Questions & Answers
L L R
How to add oil to a Carrier 06D compressor?
If the oil level is low (checked through the compressor's sight glass after 15-20 minutes of operation), add oil through the suction manifold connection on 4-cylinder compressors, or through the oil port on 6-cylinder compressors. The preferred method for a full charge is to fill the sight glass halfway when the compressor is stopped.
advertisement