Current Cost NetSmart Wireless Gateway

Place the transmitter and the Gateway in the same room. Locate the recessed tuning button on the front of the transmitter. Using a used match, pen or similar, push and hold the recessed tuning button until the LED on the transmitter has flashed once, then release. Upon releasing the red LED on the transmitter will rapidly flash for a minute. While the LED on the transmitter is flashing, use the large round button on the top of the Gateway to reach the main screen (this is the screen that shows 0). Now press and hold the large round button until the Gateway’s red LED flashes, then release the button. The main Gateway screen will pair to the transmitter, clear and then revert to normal operation.

Go to http://my.currentcost.com and click register here. Create your account by entering a user name, password and your email address. Then press submit. You will then be taken to a screen confirming that the registration has been successfully completed. Click log in. The login page will appear with your user details populated. Click log in. Once logged in, click the “+” button at the top right of the screen to register a new device. You will then be navigated to the ‘Quick Device Activation’ page. Select ‘Current Cost Wireless Gateway’ as the model from the dropdown menu, enter the serial number of your NetSmart Wireless Gateway and give it a name. Press the submit button. Your NetSmart Wireless Gateway should now be successfully registered on the Current Cost Web Dashboard.

The RJ45 Ethernet port has two LEDs: Link/Act LED is not ON, this usually means there is a bad network connection or bad cable. LED Link Activity (LINK/ACT): GREEN = link active BLINK = network activity OFF = link inactive LED 10/100: Baud Rate / Network Speed AMBER = 100Mb OFF = 10Mb