CyberPower RMCARD 205
Manuals and User Guides for CyberPower RMCARD 205. We found 4 manuals for free downloads User's manual, Quick start Guide
The CyberPower RMCARD205 and RMCARD305 Remote Management Cards allow you to remotely monitor and manage a UPS system and environmental sensor from anywhere in the world. You can access your UPS through a web browser such as Internet Explorer or Firefox. You can also use PowerPanel® Business Edition Client to gracefully shutdown servers and workstations when signaled by the Remote Management Card.
Key Features
Real time UPS monitoring
Remote management and configuration via Web Browser
Trigger servers/workstations to shutdown gracefully
Schedule shutdown/start-up/reboot of the UPS
Event logging to trace UPS history
Graphic data logging for analyzing power conditions
Save and restore configuration settings
Event notifications via Email, SNMP traps, Syslog, and SMS
Support IPv4/v6, SNMPv1/v3, HTTP/HTTPs, DHCP, NTP, DNS
Support Email Secure Authentication Protocols: SSL, TLS
Pages: 41 CyberPower RMCARD 205 User's manual
Brand: CyberPower Category: Uninterruptible power supplies (UPSs) Size: 1 MB
Languages: English
Open manualOther manuals and documents
Frequently Answers and Questions
How do I install the Remote Management Card?
The Remote Management Card can be installed by removing the expansion port cover and installing the card into the expansion port. Connect the Ethernet cable to the card and power on the UPS. The card is a hot-swap device, so you do not need to turn off the UPS to install it.
How do I configure the IP address for the Remote Management Card?
You can configure the IP address for the Remote Management Card using the Power Device Network Utility tool or using a command prompt. The Power Device Network Utility tool is available for download on the CyberPower website. To use the command prompt, you will need to obtain the MAC address from the card and use the ARP command to set the IP address. For specific instructions, please refer to the User’s Manual.
How do I access the Web Interface?
To access the Web Interface, you will need to enter the IP address of the Remote Management Card into a web browser. You will also need to enter a username and password. The default username is "admin" and the default password is "admin". You can also use the username "cyber" with the password "cyber".
How do I perform a battery test?
To perform a battery test, you can go to the UPS->Diagnostics page on the Web Interface. The Battery Test will force the UPS to switch to battery power for 10 seconds. This allows you to verify the battery conditions. If the test fails, repeat the test and replace the batteries if it fails again. Contact CyberPower for assistance if the test fails after the batteries have been replaced.
How do I set up a schedule for the UPS to shut down and restart?
You can set up a schedule for the UPS to shut down and restart on the UPS->Schedule page on the Web Interface. You can create a schedule for once, daily, or weekly. You can also set the time that the UPS should restore power.
How do I use the Wake on Lan feature?
The Wake on Lan feature is used to wake a PC through the network. Enter the IP address of the PC when it is on and the system will search its MAC accordingly. The maximum number of IP addresses that can be set is 50. Ensure the PC hardware supports this function and is configured as "Enable" under BIOS.
Questions & Answers
D D K
How many SNMP trap receivers does the system support?
The system supports setting up to 10 NMS IP (IPv6 Support) addresses as TRAP receivers. These receivers will receive an SNMP trap when an event occurs.
D D Z
How to configure the remote management card authentication for PowerPanel Business Edition Client?
The remote management card requires authentication with PowerPanel Business Edition Client via a shared secret phrase. The default secret phrase is 'powerpanel.encryption.key'. This can be configured under System->Security->Authentication in the web user interface of the RMCARD.
advertisement