Greenworks 2106902
Manuals and User Guides for Greenworks 2106902. We found 2 manuals for free downloads Owner's manual
Greenworks 2106902 is a 48V cordless string trimmer designed for efficient lawn and yard maintenance. It features a front-mounted cutting head for precise trimming, a powerful motor for cutting through tough grass and weeds, and an adjustable cutting width for versatile use. The trimmer also includes a bump feed line advancement system for easy line replacement, and a lightweight design for comfortable operation.
Key Features
48V Cordless
Front-Mounted Head
Adjustable Cutting Width
Bump Feed
Lightweight
Pages: 31 Greenworks 2106902 Owner's manual
Brand: Greenworks Category: Grass trimmers Size: 6 MB
Languages: English
Open manualOther manuals and documents
Frequently Answers and Questions
What is the cutting width of the Greenworks 2106902 string trimmer?
The cutting width of the Greenworks 2106902 string trimmer is 13 inches (33 cm).
How do I adjust the cutting width on the Greenworks 2106902 string trimmer?
You can adjust the cutting width by removing the blade screws and rotating the line cut-off blade 180 degrees. This will adjust the cutting width from 11 inches to 13 inches.
How do I advance the line on the Greenworks 2106902 string trimmer?
This trimmer uses bump feed line advancement. To advance the line, simply bump the head of the trimmer on the ground while it's rotating. The cutting blade will then trim the line to the correct length.
Questions & Answers
Y Y V
How to replace the trimmer head?
Information about how to replace the trimmer head is unavailable, but here's how to replace the spool:
- Press the tabs simultaneously on the side of the trimmer head and remove cover and spool.
- Remove any remaining line.
- Clean dirt and debris from all parts. Replace spool if it is worn or damaged.
- Replace with a pre-wound spool, or replace line using 15 feet (4.6 meters) of 0.080 inch (2.0 mm) diameter line.
- When installing new line on an existing spool, hold the spool as shown.
- Bend the line at the midpoint and insert the bend into the slot in the center rim of the spool. Ensure line snaps into position in the slot.
- With your finger between the lines, wrap the lines evenly and firmly around the spool in a clockwise direction.
- Position the lines in the guide slots.
- Place the spool in the cover as shown.
- Insert the ends of the lines through the line exit holes in the sides of the cover.
- Reinstall the spool and cover onto the trimmer head. Push until cover snaps into place.
advertisement