HME DX300 EU
Manuals and User Guides for HME DX300 EU. We found 1 manuals for free downloads Operating instructions
Below you will find brief information for Wireless Headset System DX300 EU. This system provides secure communication among the coaching staff. Spotters in the press box can communicate with offense “O” only, defense “X” only or “ALL” coaches via headsets connected directly to the base station. Coaches on the sideline wear beltpacs with headsets to communicate with each other and the spotters. Beltpacs can be set up for communication with any combination of offense, defense and ALL. This system has two modes of operation: Single-channel (SNGL) mode and Dual-channel (DUAL) mode. In single-channel (SNGL) mode ― four beltpacs can be used in the hands-free mode, communicating in “O” channel only. In the dual-channel (DUAL) mode ― three beltpacs can be used in the hands-free mode, communicating in either “O” or “X” channel, or “ALL” (both channels).
Key Features
Secure communication among the coaching staff
Spotters in the press box can communicate
Coaches on the sideline wear beltpacs with headsets
Beltpacs can be set up for communication with any combination of offense, defense and ALL
Two modes of operation: Single-channel (SNGL) and Dual-channel (DUAL)
Up to 20 coaches can communicate by interconnecting up to four base stations
Remote antenna installation
Auxiliary equipment connection
Microphone gain adjustment
Pages: 34 HME DX300 EU Operating instructions
Brand: HME Category: Microphones Size: 3 MB
Languages: English
Table of contents
Open manualFrequently Answers and Questions
How many coaches can communicate using the DX300 system?
Up to 20 coaches can communicate using the DX300 (five per base station) by interconnecting up to four base stations.
How to connect multiple base stations?
Connect base stations with the provided interconnect cable, from the BASE OUT connector on one to the BASE IN connector on the other.
What are the battery life of the base station?
Typical base station battery life when used continuously is as follows: Energizer ULTIMATE Lithium . . . . . . . . . . . . . . . . 5 hours BAT850 Rechargeable Battery . . . . . . . . . . . . . . . 2¼ hours Duracell Quantum . . . . . . . . . . . . . . . . . . . . . . . 35 minutes
How do I adjust the microphone gain on the base station?
The microphone gain adjustment allows you to adjust the level of your voice as it is transmitted from the headsets plugged into the base station Microphone gain must be adjusted for each base station headset. Using a headset plugged into the right side of a base station, locate the recessed MIC GAIN adjustment hole on the right side of the base station. Insert a small screwdriver in the hole, and turn the adjustment clockwise (to increase) or counterclockwise (to decrease) microphone gain. Speak into the right headset microphone and listen to your voice level (sidetone) as you adjust the microphone gain. Using a headset plugged into the left side of the base station, locate the MIC GAIN adjustment on the left side of the base station, and then repeat Steps 2 and 3. Repeat Steps 1 through 4 for each base station.
How to change the mode of the beltpac?
Set up beltpacs to operate in the desired mode by pressing and holding the button combinations shown below. Button combinations work in unison with the PWR (power) button.
advertisement