HP 3000
Handbücher und Benutzerhandbücher für HP 3000. Wir haben 16 handbücher zum kostenlosen Download Application Note, Reference manual, installation Guide, Service manual, User's Guide, Setup Guide, User Guide, Getting started guide
Below you will find brief information for 3000. This application note outlines the port facility in MPE/XL, detailing message transmission, process synchronization, and task priority management through ports and subqueues.
Hauptfunktionen
Message Ports for inter-process communication
Signal Ports for event triggering
Subqueues for message priority
Architected Interface for program integration
Andere Handbücher und Dokumente
Häufige Antworten und Fragen
What is a PORT?
A port is a data structure dedicated to the reception of messages in MPE/XL.
What is a SUBQUEUE?
Each PORT is divided into a set of SUBQUEUES (up to 32 per PORT), which actually represent the various chained lists that are attached to a given PORT.
What is a PORT SERVER?
A SERVER is a specific section of code which knows where to read and how to process a message on a given PORT.
Fragen und Antworten
A A U
How to troubleshoot memory failure issues with the device?
The viewed document does not contain specific troubleshooting steps for memory failures. However, it provides information on how to check DIMM installation and enabling memory, which might be helpful. If an error message appears after turning on the printer, it suggests that a DIMM might have been incorrectly installed. To ensure proper functionality: 1. Verify DIMM Installation: Follow the instructions in the manual to correctly install the memory DIMMs. 2. Enable Memory: After installing a memory DIMM, ensure that the printer driver recognizes the newly added memory. 3. Check DIMM Installation: Check that the DIMMs are installed correctly and working. If an error message appears, a DIMM might have been incorrectly installed.
R R Y
How should the ETB attaching roller be cleaned, and what precautions should be taken?
Clean the ETB attaching roller using lint-free paper. If dirt is difficult to remove, the paper can be dampened with alcohol. Caution: Do not touch the ETB (Electrostatic Transfer Belt) itself with a damp cloth or your fingers to avoid potential damage.
B B T
How to remove and replace the developing separation-drive assembly?
Remove the upper cover, right cover, and fuser. Use a flatblade screwdriver to release the wire-guide locking tab and move it forward. Remove the sheet-metal plate (three screws), disconnect connectors J403 and J405 from the driver PCA, and remove the wire harnesses from the retainers. Finally, remove the three screws to release the assembly, ensuring the non-captive upper drive gear remains in place.
Q Q E
How to replace the fuser in HP Color LaserJet 3000/3600/3800 series printers?
To replace the fuser, ensure the printer is off and cooled. Open the upper door, squeeze the two blue locking levers, release the unit, and rotate it out.
What troubleshooting steps should be taken if the HP Color LaserJet 3000/3600/3800 series printer does not power on?
Verify the power cord connection, ensure the on/off switch is in the 'on' position, and check if the formatter is correctly seated (if fans and motors operate but the control panel is dark). It is also recommended to perform a power-on check or consult the troubleshooting flowchart.
Z Z X
How to print a test page?
To print a test page, refer to the documentation for instructions. Several test page types exist, including engine, formatter, half-self, and drum-rotation tests.
Werbung