HeatStar HS35LP
Manuals and User Guides for HeatStar HS35LP. We found 2 manuals for free downloads User manual
Below you will find brief information for gas-fired infrared portable construction heater HS35LP. The HS35LP is a portable construction heater designed to be used in construction, alteration, or repair of buildings. This heater uses LP-Gas and features a tip-over switch that automatically shuts off the burner if the heater is accidentally tipped over. It also features a 100% safety shutoff, push button valve that automatically stops the flow of gas in the event the heater fails to operate for any reason. Ensure adequate ventilation when using it.
Key Features
- Portable construction heater
- LP-Gas powered
- Tip-over safety switch
- 100% safety shutoff valve
- Designed for construction use
Pages: 16 HeatStar HS35LP User manual
Brand: HeatStar Category: Space heaters Size: 1 MB
Open manualOther manuals and documents
Frequently Answers and Questions
How do I light the HS35LP heater?
Turn off the main gas supply to the appliance. Wait five minutes. Turn on the main gas supply. Depress the red spark ignition button repeatedly, or with a lighted match held to the burner face, depress and hold the reset button on the safety valve. After the burner ignites, hold the reset button depressed for about one minute or until the burner stays lit. DO NOT light the gas at the burner orifice. DO NOT face the heater when attempting to light. Always stand to the side of the unit when lighting.
What is the minimum ambient temperature rating for the HS35LP heater?
The minimum ambient temperature rating for this heater is 20 degrees F.
What are the clearance requirements for the HS35LP heater?
The HS35LP heater requires the following minimum clearances to combustible materials: Top: 40”, Sides: 40”, Back: 0”, Front: 54”.
How do I clean the HS35LP heater?
Turn the heater off and wait until it has completely cooled (at least 20 minutes) before cleaning. Clean the outside of the heater using a damp cloth. DO NOT clean the heater by spraying water on it. Wipe the outside of the heater off with a dry cloth after cleaning. Clean the inside of the heater using compressed air. Blow air back and forth along the entire burner face until all dust has been dislodged from the surface of the reverberator and grid screen. Blow through the venturi from the control end of the heater. Clean the orifice of each burner with a #55 drill bit (for LP-Gas). Clean the thermocouple lead.
How do I shut down the HS35LP heater?
Close the LP-Gas supply cylinder valve. Observe the burner until the flame is extinguished. Listen for the closure of the safety valve. DO NOT re-open the LP-Gas supply cylinder valve before the safety valve closes.
advertisement