Helion RC Invictus 10MT

Turn on the transmitter first, then the vehicle. The LED on the receiver will blink, indicating that the receiver is not bound to a transmitter that is on. With the transmitter OFF, hold the REV/BIND button and turn the power ON to put the transmitter into binding mode. Push the button on the receiver once, the LED will start to blink faster indicating it is searching for a transmitter to bind with. The transmitter will automatically search and bind to the receiver. This may take up to 10 seconds. Once the transmitter and receiver are bound together, the receiver's LED will turn solid red. If the receiver's LED does not turn solid red, turn off both the transmitter and receiver and repeat steps 1-2. Once binding is complete, turn the power off and back on to both the transmitter and receiver. Ensure normal operation of throttle and steering. If binding to a different vehicle you may need to reverse the steering channel on your transmitter to work properly. If you experience anything other than normal operation, repeat the process.

If the wheels spin in a forward direction when the trigger is in the neutral position, turn down the trim until the motor stops by pressing the TH- button, repeatedly if necessary. If the wheels spin in a reverse direction when the trigger is in the neutral position, turn up the trim until the motor stops by pressing the TH+ button, repeatedly if necessary. There will be a “dead band” area where the trim can be adjusted a slight amount in either direction and the wheels will not begin to move. It is ideal to have the trim set in the middle of this “dead band”.

The Reaktor ESC has 3 built in running modes with different acceleration profiles and correlating LVC settings. It is essential that you use the proper running mode for the type of battery that your are using to achieve the optimal performance from your ESC and motor. These 3 modes are indicated LED blinking the number of times stated, the LED will pause before repeating the signal. Off: (Indicated by 1 blink of the LED) If you plan to use high performance NiMH batteries of 3000mAh or above it is recommended to turn off the LVC mode to obtain best performance from your batteries. LiPo: (Indicated by 2 blinks of the LED) Use the LiPo mode whenever you use a LiPo battery with your ESC. It will protect your battery from over-discharge. When running a LiPo battery it is required to use High Current connectors such as our HCT-Plug. The included battery connector is compatible. We recommend using compatible batteries equipped with W.S. Deans Ultra-Plugs (WSD1300) available at your local hobby dealer. If you prefer to use another type of connector, it is critical that the connector be changed and that you do not try to use an adapter in this application. NiMH: (Indicated by 3 blinks of the LED) Using the supplied 3000mAh battery requires that you use the NiMH mode to ensure proper operation of your ESC and maximized performance from your batteries. Your ESC is pre-configured to this setting.