Imagine communications Manual Transfer Switch Control Panel

Manuals and User Guides for Imagine communications Manual Transfer Switch Control Panel. We found 1 manuals for free downloads User manual

Below you will find brief information for ADC Hardware Control Panels, 8-Port Transfer Relay Panel, GPI Breakout Panel, Manual Transfer Switch Control Panel, Cloning Control Panel, Keyboard/Video/Mouse Switch, Operator Control Panel, Ingest Control Panel. This manual provides guidance on installing and configuring these hardware control panels for automation systems, including serial control switching, GPI configuration, manual transfer setup, cloning operations, KVM switch wiring, and operator/ingest control panel configurations.

Key Features

  • Serial control switching

  • Manual transfer switching

  • Cloning operations

  • GPI breakout panel

  • Manual transfer switch control

  • KVM switch wiring

  • Operator control panel configuration

  • Ingest control panel configuration

Pages: 50 Imagine communications Manual Transfer Switch Control Panel User manual

Brand: Imagine communications Category: KVM switches Size: 1 MB

Languages: English

Table of contents

Open manual

Frequently Answers and Questions

How do I configure the internal jumpers of the 8-Port Transfer Relay Panel for cloning?

For each set of 4 jumpers in each one of the 8 connectors, verify that the jumpers are on both pins.

How do I configure a GPI input to utilize the GPI breakout panel’s power supply?

Set the jumpers as shown in the manual, with +12V connected to High and Gnd connected to Low.

What is the purpose of the Manual Transfer Switch Control Panel?

It allows an operator to use a manual panel selection to transfer device control from one Device Server to another.

What does the Cloning Control panel do?

It monitors the status of the Device Servers and switches the Transfer Relay panels as appropriate for automatic transfer of device control.

How do I connect the GPI cards to the breakout panels?

Connect an HD-44 cable from each GPI card to the connector on the rear of the breakout panel.

advertisement