Imagine communications QS100HD
Manuals and User Guides for Imagine communications QS100HD. We found 1 manuals for free downloads User manual
The QS100HD is an HD four-window display processor card designed specifically for selected Sony LMD production monitors. It is configurable as a Quad-split or any 4 window arrangement. It can drive LMD HD displays up to a resolution of 1920 x 1080, with autosensing of analog composite, SDI and HD-SDI inputs. The QS100HD enhanced graphics engine delivers pristine image quality and can reproduce fine details even for small video windows. Each video input is equipped with an advanced de-interlacing and scaling engine to ensure high quality monitoring.
Key Features
4 auto-sensing HD SDI, SDI and composite video inputs
Full-screen, quad-split and any 4-window display configuration
10-bit resolution for all digital inputs
Control options include ZConfigurator software, LMD front panel for full screen selection of any source, GPI and LAN
Supports embedded audio metering with up to 16 in-picture audio meters per video window
4 GPI inputs for external triggers
Pages: 40 Imagine communications QS100HD User manual
Brand: Imagine communications Category: TVs & monitors Size: 2 MB
Languages: English
Table of contents
Open manualFrequently Answers and Questions
What is the typical delay through a QS100HD multiviewer?
The total video delay is somewhere between 0.5 to 1 frame of video depending on the relative timing of the incoming sources.
How do I find out my multiviewer IP address?
To find out the current IP address of the multiviewer check the splash screen on the LCD during boot up. The IP address will be displayed for a few seconds.
Why can’t I see any output?
This problem might occur if the display output cannot support the resolution of the attached display. Check that there is power to the LMD display unit and that the QS100HD module is inserted correctly. Check that one or more valid input signal(s) are connected and that the chosen PiPs or Tiles correspond to valid input(s). Ensure that the supplied short DVI cable is connected securely between the QS100HD and the LMD in which it is installed.
What is the DVI-I format and how do I use it?
The QS100HD is equipped with a DVI-D Display Output Microcross connector which outputs a digital video signal and does NOT have analog signals. Pin-out is given in the Installation chapter. Cable length for digital signals may be as low as 2 meters, but can be increased using DVI extenders.
Can I use a DHCP server to assign IP addresses?
A DHCP server dynamically allocates IP addresses. Although this might appear to make system administration easy, we recommend fixed addressing. This is because it works well with UMD Tally controllers which only recognize a multiviewer by its IP address and not its name. DHCP servers may choose to change assigned addresses which would cause external controllers to lose connection with multiviewers. The QS100HD does not currently support Dynamic addressing from a DHCP server.
advertisement