Isodaq Hawk XT
Manuals and User Guides for Isodaq Hawk XT. We found 1 manuals for free downloads User Guide
Below you will find brief information for Telemetry Logger Hawk XT. This product is a telemetry data logger used to collect data from sensors in remote locations. It takes measurements from single or multi-parameter sensors at regular intervals and stores this data in internal memory. Using GPRS, GSM or PSTN telemetry, the Hawk XT contacts a data collection system, typically once per day, and transfers data to the data collector. The Hawk XT can also be configured for alarms with user-specified set points. When a measurement exceeds a set point, the Hawk XT contacts the data collector and transfers data along with an alarm message. The Hawk XT manages power to both the modem and sensors. Internal Alkaline cells can be fitted. Power can also be taken from an external DC source.
Key Features
Telemetry data logger
GPRS, GSM, or PSTN telemetry
Alarm configuration with user-specified set points
Internal Alkaline batteries
External DC power source
2 sensor card channels
SDI-12 channel for smart sensors
Pages: 64 Isodaq Hawk XT User Guide
Brand: Isodaq Category: Electrical equipment & supplies Size: 2 MB
Languages: English
Open manualFrequently Answers and Questions
What types of sensors can be used with the Hawk XT?
The Hawk XT can be used with a variety of sensors, including water level sensors, 4-20mA submersible transmitters, ultrasonic transmitters, shaft encoders, tipping-bucket rain gauges, rainfall intensity alarms, process sensors, water quality sensors, and temperature sensors.
How does the Hawk XT manage power?
The Hawk XT manages power to both the modem and sensors. It can be powered by internal Alkaline cells or an external DC source. The modem can be switched on and off using time-switching or check-in calls.
What alarm capabilities does the Hawk XT have?
The Hawk XT can be configured for alarms with user-specified set points. When a measurement exceeds a set point, the Hawk XT contacts the data collector and transfers data along with an alarm message.
How do I configure the Hawk XT for telemetry?
The Hawk XT can be configured for telemetry using the Harvest software. You will need to select the correct telemetry protocol (DNP3 or Modbus) and configure the check-in times and dial numbers.
Questions & Answers
Z Z G
Can a SIM card be installed in the device, and how is it done?
Yes, a SIM card can be fitted for GPRS, GSM, or PSTN telemetry. To install the SIM: open the logger's lid, locate the SIM holder on the main board, slide the metal bar, insert the SIM with contacts down and the cut corner pointing outwards, fold the holder down, and slide the metal bar to lock it.
advertisement