218 Manuals

Lumel N14

Manuals and User Guides for Lumel N14. We found 3 manuals for free downloads User's manual, User manual, Manual

Below you will find brief information for network parameter meter N14 N14. This programmable digital panel instrument is designed to measure 3-phase, 3 or 4-wire power network parameters in balanced or unbalanced systems. It displays measured values and transmits them digitally via the RS-485 interface. It also offers features such as control and optimization of power electronic devices, systems and industrial installations. You can use this meter to measure RMS voltage and current, active, reactive and apparent power, active and reactive energy, power factors, frequency, and mean active power (e.g. 15-min mean power).

Key Features

Measures 3-phase power network parameters
Displays measured values
Transmits data digitally via RS-485 interface
Programmable
Measures RMS voltage and current
Measures active, reactive, and apparent power
Measures active and reactive energy
Measures power factors
Measures frequency
Measures mean active power

LUMEL network parameter meter N14 User's Manual

Pages: 32 Lumel N14 User's manual

Brand: Lumel Category: Measuring, testing & control Size: 1 MB

Languages: English

Open manual

Frequently Answers and Questions

What are the basic requirements and operational safety for this meter?

The meter meets the requirements of EN 61010-1 standard. Qualified skilled personnel should carry out all operations concerning the meter installation and connections, and national regulations for the prevention of accidents must be observed.

How do I mount the meter?

The meter is adapted to be mounted in a panel by means of holders. Prepare a hole of 91+0.5 ´ 91+0.5 mm in the panel, the thickness of which should not exceed 6 mm. The meter must be introduced from the panel front with disconnected supply voltage. At the rear side of the meter, there are terminal strips which enable the connection of wires up to 2.5 mm2.

How do I program the meter?

To enter the programming mode, press and hold the 'up' and 'down' buttons for approximately 3 seconds. The entry is protected by an access code. To set parameters, select the mode 'P', 'C', or 'A' in options and confirm your choice with the 'Enter' button. You can then use the 'up' and 'down' buttons to select the value and the 'Enter' button to confirm your selection.