MK Diamond MK-24 Series MK-2420HSP

Manuals and User Guides for MK Diamond MK-24 Series MK-2420HSP. We found 1 manuals for free downloads Manual

Below you will find brief information for Concrete Saw MK-24 Series MK-2420HSP, Concrete Saw MK-24 Series MK-2424HSP, Concrete Saw MK-24 Series MK-2422SSP, Concrete Saw MK-24 Series MK-2425KSP. The MK-24 Series is a versatile gas powered concrete saw, powered by a Honda or Subaru gas engine or a propane engine by Kohler or Subaru. It is capable of a 9-3/4” depth of cut with a 24” blade.

Key Features

  • One-piece box construction chassis
  • Powder-coated chassis
  • 12-gauge hinged blade guard
  • Ride-on-the-blade water distribution system
  • Heavy-duty blade shaft
  • Depth control assembly
  • Heavy-duty hydrostatic transmission
  • Durable 8” x 2-1/4” non-slip rubber wheels

Pages: 36 MK Diamond MK-24 Series MK-2420HSP Manual

Brand: MK Diamond Category: Industrial & lab equipment Size: 2 MB

Languages: English

Open manual

Frequently Answers and Questions

How do I adjust the pointer?
Use a straight edge to mark a 12 foot line on a smooth level concrete surface. Place the saw parallel to the line, lower the blade, and center it over the line. With the blade centered over the line and the saw frame parallel to the line, lower the front pointer assembly and position the pointer over the line. Adjust the pointer in or out if the orange wheel is off the line by loosening the thumbscrew on the end of the pointer. Align the orange wheel with the line and tighten the thumbscrew. Roll the saw along the entire length of the line to ensure proper alignment.
How do I change the oil?
Refer to the engine manual for details. The engine is shipped with no oil in the crankcase. Make sure the engine and oil are warm and your saw is on level ground to get an accurate oil level reading. Check the engine manual for details on the type and amount of oil required.
How do I adjust the depth of cut?
Turn the depth control wheel until the blade touches the ground. Then, turn the depth gauge indicator dial clockwise until it reads zero.

advertisement