268 Manuals

Microscan MS-3 Laser Scanner

Manuals and User Guides for Microscan MS-3 Laser Scanner. We found 6 manuals for free downloads User's manual, Quick start Guide, User manual

Below you will find brief information for Laser Scanner MS-3 Laser Scanner. The MS-3 is an ultra-compact scanner that can decode high density symbols from 2 to 10 inches at a 70 degree scan angle, at speeds of 300 to 1,000 decodes per second, with a power draw of only 300mA at 5V. The multi-function EZ button can be used for read rate tests and automatic calibration right out of the box, and it can also be programmed to perform a variety of other functions.

Key Features

Ultra-compact scanner
Decode high density symbols
Read rate tests and automatic calibration
Multi-function EZ button
Programmable relay outputs
Master and trigger inputs
Configurable with ESP
Decode speeds up to 1,000 decodes per second
Power draw of only 300mA at 5V

Pages: 224 Microscan MS-3 Laser Scanner User's manual

Brand: Microscan Category: Measuring, testing & control Size: 7 MB

Languages: English

Open manual

Frequently Answers and Questions

How can I connect the MS-3 scanner to a host computer?

Connect the scanner to the “SCANNER” connector on the IC-332 interface converter using the attached 3-foot cable. Connect the IC-332 directly to the "SCANNER" 15 pin connector on the IB-131. Connect the host computer to the IB-131 “HOST” 25-pin connector via the null modem cable.

How do I test the read rate of the MS-3 scanner?

Click the EZ Button in Easy Setup Mode to begin the read rate test. Follow the instructions in Easy Setup Mode screen. To end the Read Rate test, click the Stop button.

How do I calibrate the MS-3 scanner?

Click the Calibrate button in Easy Setup Mode to begin the read rate test. You can observe the progress of the calibration routine on the Calibration popup.

How do I save the calibration settings for power-on?

After testing and/or calibrating the scanner, you can save the settings for power-on by clicking the Save button in ESP.

How do I configure the MS-3 scanner using serial commands?

From your terminal program or the terminal screen in ESP, you can enter serial string commands and configuration and utility commands as described in this manual. See "Serial Configuration Commands" on page A-13 and "Summary of Utilities Commands" on page 11-3.