Minolta 1100

Make sure that the printer and the computer you are connecting it to are both turned off. Connect one end of the interface cable to the parallel port of the computer. Connect the other end of the interface cable to the parallel interface connector on the back of the printer. Secure the interface cable using the two clips on the parallel interface connector.

You can use the following methods to install the PagePro 1100 Printer Driver: Using the auto-run Installer on the CD-ROM. Plug-and-Play installation. Using the Add Printer Wizard.

Open the face-down tray. Pull Tray1 from the printer with both hands and lie it down flat. Squeeze the right paper guide and open the paper guides. Place a stack of paper in the center of Tray1. Squeeze the right paper guide and adjust the paper guides so that both the left and right sides of the paper stack are secure.

Remove the second paper cassette unit and Tray2 from their packaging, including the protective tape used to hold the various components in place. Place the printer on top of the base unit. Make sure to align the coupling pins of the base unit with the holes located underneath the printer. Remove the cover from Tray2. Press down on the paper lifting plate located inside of Tray2 until it locks. Place a stack of up to 500 sheets of paper into Tray2 so that the side that was facing up when the paper was unwrapped is still facing up. Replace the cassette cover and insert Tray2 into the second paper cassette unit.

Remove the face-up tray from its carton. Gently bend the output tray inwards, toward the printer, with both hands. Align the insertion pins of the tray with the pin holders of the printer. Use the switch which is located on the right-rear side of the printer and select the output direction.