167 Manuals

Mopar Challenger

Manuals and User Guides for Mopar Challenger. We found 2 manuals for free downloads Owner's manual, Instructions

Below you will find brief information for center stack & shifter bezel Challenger. This document provides instructions on how to remove, replace, and install a new center stack and shifter bezel. It also includes instructions on how to calibrate the actuator function after installation. The document includes warnings about the airbag system, and the importance of taking proper precautions to avoid accidental deployment.

Key Features

Airbag system disablement
Center stack & shifter bezel replacement
Actuator calibration
Proper precautions for airbag system
Detailed procedures for removing and installing parts.

Pages: 364 Mopar Challenger Owner's manual

Brand: Mopar Category: Cars Size: 17 MB

Languages: English

Open manual

Frequently Answers and Questions

How do I disable the airbag system before proceeding with the repair?

Disconnect and isolate the negative battery cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service.

What are the steps involved in removing and installing the center stack and shifter bezel?

Follow the steps outlined in the document, starting with disconnecting the battery cable and removing the shifter trim ring and console trim plate. You'll then remove the center bezel, disconnect electrical connectors, and remove the heater control and hazard switch. Finally, install the new bezel and re-connect the battery cable.

What is the actuator calibration function and when should I use it?

The actuator calibration function is automatically performed when a new A/C-heater control is installed or the original control is reinstalled. It is however, recommended to manually initiate the function using a scan tool if the A/C-heater control has been previously installed in another vehicle.